Key Laboratory of the Atmospheric Composition and Optical Radiation, CAS, School of Earth and Space Sciences University of Science and Technology of China Hefei China
Auto-generated profile, based on publicly available information
Xue Dong
Key Laboratory of the Atmospheric Composition and Optical Radiation, CAS, School of Earth and Space Sciences University of Science and Technology of China Hefei China
Diurnal variation of surface PM2.5 concentration (diurnal PM2.5) could dramatically affect aerosol radiative and health impacts and can also well reflect the physical and chemical mechanisms of air pollution formation and evolution. So far, diurnal PM2.5 and its modeling capability over East China have not been investigated and therefore are examined in this study. Based on the observations, the normalized diurnal amplitude of surface PM2.5 concentrations averaged over East China is weakest (∼1.2) in winter and reaches ∼1.5 in other seasons. The diurnal PM2.5 shows the peak concentration during the night in spring and fall and during the daytime in summer. The simulated diurnal PM2.5 with WRF-Chem and its contributions from multiple physical and chemical processes are examined in the four seasons. The simulated diurnal PM2.5 with WRF-Chem is primarily controlled by planetary boundary layer (PBL) mixing and emission variations and is significantly overestimated against the observation during the night. This modeling bias is likely primarily due to the inefficient PBL mixing of primary PM2.5 during the night. The simulated diurnal PM2.5 is sensitive to the PBL schemes and vertical-layer configurations with WRF-Chem. Besides the PBL height, the PBL mixing coefficient is also found to be the critical factor determining the PBL mixing of pollutants in WRF-Chem. With reasonable PBL height, the increase in the lower limit of the PBL mixing coefficient during the night can significantly reduce the modeling biases in diurnal PM2.5 and also the mean concentrations, particularly in the major cities of East China. It can also reduce the modeling sensitivity to the PBL vertical-layer configurations. The diurnal variation and injection height of anthropogenic emissions also play roles in simulating diurnal PM2.5, but the impact is relatively smaller than that from the PBL mixing. This study underscores that more efforts are needed to improve the boundary mixing process of pollutants in models with observations of PBL structure and mixing fluxes in addition to PBL height, in order to simulate reasonably the diurnal PM2.5 over East China. The diurnal variation and injection height of anthropogenic emissions must also be included to simulate the diurnal PM2.5 over East China.
Mineral dust is the most important natural source of atmospheric ice nuclei (IN) which may significantly mediate the properties of ice cloud through heterogeneous nucleation and lead to crucial impacts on hydrological and energy cycle. The potential dust IN effect on cloud top temperature (CTT) in a well-developed mesoscale convective system (MCS) was studied using both satellite observations and cloud resolving model (CRM) simulations. We combined satellite observations from passive spectrometer, active cloud radar, lidar, and wind field simulations from CRM to identify the place where ice cloud mixed with dust particles. For given ice water path, the CTT of dust-mixed cloud is warmer than that in relatively pristine cloud. The probability distribution function (PDF) of CTT for dust-mixed clouds shifted to the warmer end and showed two peaks at about −45 °C and −25 °C. The PDF for relatively pristine cloud only show one peak at −55 °C. Cloud simulations with different microphysical schemes agreed well with each other and showed better agreement with satellite observations in pristine clouds, but they showed large discrepancies in dust-mixed clouds. Some microphysical schemes failed to predict the warm peak of CTT related to heterogeneous ice formation.
27 August 2018 in Journal of Geophysical Research: Atmospheres
The current study investigates the potential impacts of Sahara dust on rainfall vertical structure over the Atlantic Ocean by employing multisensor satellite observations. The variabilities in rainfall vertical structure are decomposed by empirical orthogonal function (EOF) analysis. For a given near surface rain rate, the mean storm height of stratiform rain under dust‐laden condition is significantly higher than that under the dust‐free condition. The stratiform rain rate at the layers well above the freezing level is substantially enhanced under dust‐laden condition. Those changes may result from dynamic and thermodynamic effect of Sahara Air Layer effect and/or the effect that dust aerosol acting as additional ice nuclei. For convective rain, there is no significant difference in the leading three normalized EOF modes between the dust‐laden and dust‐free sectors, implying that dust effect, if exists, is not strong enough to cause evident changes in convective rainfall profiles. For stratiform rain, the EOF1 shows no signals of dust effect either. However, significant difference is found in the EOF2 and EOF3 modes between dust‐laden and dust‐free conditions. The normalized EOF2 and EOF3 under dust‐laden condition both represent enhanced rain rate at the upper layer well above the freezing level, where heterogeneous ice nucleation prevails. The statistical study shows consistent results with the case study, except that the aerosol‐related changes in stratiform rainfall vertical structure is isolated in the EOF3 only. This study suggests that EOF analysis is a promising way for isolating the potential and relatively weak aerosol effects on precipitation from the strong dynamic effects.
Through observations from the Cloud‐Aerosol Lidar with Orthogonal Polarization onboard the Cloud‐Aerosol Lidar and Infrared Pathfinder Satellite Observation, we detected a common feature of narrow and subvisible lateral boundary layer in cirrus cloud. In this layer the lidar backscatter, the depolarization ratio, the ice water content, the effective radius of ice particles, and the cloud optical depth all decrease sharply toward the cloud edge. In general, the width of this layer (6.4 ± 3.1 km over land) decreases with increasing ambient temperature. The estimated longwave radiative forcing associated with the layer is about 10 W/m2. Due to its extremely small optical depth (less than 0.3), such lateral boundary layer may be missed by conventional satellite passive optical sensors. As a consequence, the mentioned radiative forcing has not been credited with its deserved share in the Earth's radiative energy budget.
25 August 2015 in Journal of Geophysical Research: Atmospheres
The cloud water content (CWC) in rainy clouds is a crucial parameter to determine the onset and the growth rate of precipitation and to quantify the associated latent heating rate. No direct retrieval of CWC in rainy cloud from satellite observations is reported due to the difficulties of separating cloud particles from precipitation‐sized particles. However, based on multiple cloud simulations from the Weather and Research Forecasting (WRF) model, we have found that the CWC profile in warm rains can be well determined by three macrophysical cloud properties of cloud water path (CWP), cloud top height (CTH), and cloud bottom height (CBH). The CBH can be estimated using CWP, CTH, and near‐surface rain rate. We proposed an algorithm with a look‐up table for estimating the CWC profile using CWP, CTH, and near‐surface rain rate as inputs. The performance of this algorithm was tested with WRF model simulations and a real drizzle case observed by the CloudSat satellite. Testing verified that the algorithm can retrieve the vertical distribution of CWC correctly with few errors at different spatiotemporal scales. In addition, the algorithm is not confined to particular microphysics schemes and is valid for multiple cloud systems in different areas over the world. This algorithm is expected to improve current knowledge of cloud water content in rainy clouds.
In this paper, the global distribution of cloud water based on International Satellite Cloud Climatology Project (ISCCP), Moderate Resolution Imaging Spectroradiometer (MODIS), CloudSat Cloud Profiling Radar (CPR), European Center for Medium-Range Weather Forecasts Interim Re-Analysis (ERA-Interim), and Climate Forecast System Reanalysis (CFSR) datasets is presented, and the variability of cloud water from ISCCP, the Special Sensor Microwave Imager (SSM/I), ERA-Interim, and CFSR data over the time period of 1995 through 2009 is discussed. The results show noticeable differences in cloud water over land and over ocean, as well as latitudinal variations. Large values of cloud water are mainly distributed over the North Pacific and Atlantic Oceans, eastern ITCZ, regions off the west coast of the continents as well as tropical rain forest. Cloud water path (CWP), liquid water path (LWP), and ice water path (IWP) from these datasets show a relatively good agreement in distributions and zonal means. The results of trend analyzing show an increasing trend in CWP, and also a significant increasing trend of LWP can be found in the dataset of ISCCP, ERA-Interim, and CFSR over the ocean. Besides the long-term variation trend, rises of cloud water are found when temperature and water vapor exhibit a positive anomaly. EOF analyses are also applied to the anomalies of cloud water, the first dominate mode of CWP and IWP are similar, and a phase change can be found in the LWP time coefficient around 1999 in ISCCP and CFSR and around 2002 in ERA-Interim.