18 September 2022 in Ocean Engineering
28 June 2021 in Celal Bayar Üniversitesi Fen Bilimleri Dergisi
Pipe flow problems are important in transportation of wastewater, oil lines and supply of water. In this study, a non-Newtonian fluid model is discussed and a numerical CFD solution is presented for flow geometry. The effects on velocity, pressure, dynamic viscosity and cell Reynolds number are discussed for different parameters of flow inside the pipe. Power Law function is considered in the analyses.
20 March 2022 in European Mechanical Science
In this study, the stress and deformation behavior of two I-corner plates with rivet connection in bending and tension were investigated. Pure bending and axial tension were applied at the end edge as the boundary condition and fixed support was defined at the other end edge of the plates. The finite element method was used. A suitable validation study was conducted, and its results were compared with the literature cases. A surface pressure was applied to the rounded I-corner. The results are shown in the form of the stress concentration factor. The time-dependent response of applied pressure was also performed to observe the dynamic behavior. The stresses in the plates occurred at the calculated values and as a result the stress concentration factor was about 1.0. The stress concentration factor of the plate in the rivet region is I=0.2 and in the rivets goes up to 5.0. The results are discussed in detail.
29 June 2023 in Celal Bayar Üniversitesi Fen Bilimleri Dergisi
In this study, flow behavior behind a breakwater was investigated for plane-based model. In the examination, straight models at different position angles were used for the breakwater. Dynamic inlet flow was used, and the wave model has been applied in commonly used two-row amplitude. The focus is on the area between the breakwater and the coastline, which is important for the use of breakwaters. The usage of Θ=+80 position angle in placement of straight breakwater gives the most suitable response. The results were discussed in detail.
31 May 2023 in Kocaeli Journal of Science and Engineering
Building systems have unique structural behaviour. In addition to the obvious material properties used in the formation of this behaviour, the geometric shape is also of great importance. In this study, the mechanical effects on the chimney-shaped structure built with bar bricks for product storage were investigated under compression and vibration conditions. Finite element analysis was used as a research method. Solid bar bricks and cement with standard specifications were used as the intermediate filling material for the construction system, which was formed in a wide circular array and short knitting height. Considering the ideal behaviour of the materials, a fully elastic solution was made. As a result of the examination, the effect of the knitting order on the natural frequency was found to be low, as the reason for this, it was seen that the geometric structure exhibited a very tough behaviour against deformation. The stress concentration was observed at the fillings between the bricks laid in the same layer. The dimensionless deformation at natural frequencies was 1.4 times the diameter of the chimney. The knitting order affected stress values and symmetrical distribution formed in the brick. The results were discussed over the findings.
4 July 2023 in Natural and Applied Sciences Journal
In this study, the effect of adding a support sleeve for a pipe connection with 6 bolts of equivalent distance was investigated. The research was carried out with a package program that is widely used in finite element analysis. The lip geometry used for bolts and connection has been simplified for ease of analysis. As a material, steel with standard features was used in the models and static analyses were made. Factors that the connection may encounter most in operating conditions; The axial tension between the pipes, the internal pressure within the pipe and the bending effect with an applied moment were investigated. In addition, the pre-loading condition applicable to the bolts was applied as displacement to all 6 bolts for tensile condition and to 3 bolts subjected to tension for bending condition. In the results, the connection region was determined as the region where the stresses were concentrated under all different loading conditions and it was seen that the applied support sleeve did not show any benefit in reducing the stresses. It was determined that the preload applied to the bolts increased the stresses. Preloading only had a limited positive effect on the bending behaviour.