8 January 2020 in Complexity
This paper studies an advanced intelligent recognition method of underwater target based on unmanned underwater vehicle (UUV) vision system. This method is called kernel two-dimensional nonnegative matrix factorization (K2DNMF) which can further improve underwater operation capability of the UUV vision system. Our contributions can be summarized as follows: (1) K2DNMF intends to use the kernel method for the matrix factorization both on the column and row directions of the two-dimensional image data in order to transform the original low-dimensional space with nonlinearity into a higher dimensional space with linearity; (2) In the K2DNMF method, a good subspace approximation to the original data can be obtained by the orthogonal constraint on column basis matrix and row basis matrix; (3) The column basis matrix and row basis matrix can extract the feature information of underwater target images, and an effective classifier is designed to perform underwater target recognition; (4) A series of related experiments were performed on three sets of test samples collected by the UUV vision system, the experimental results demonstrate that K2DNMF has higher overall target detection accuracy than the traditional underwater target recognition methods.
3 January 2019 in Mathematical Problems in Engineering
A fault‐tolerant supervisory control method for dynamic positioning of ships with actuator failures and sensor failures is presented in this paper. Unlike the traditional fault detection and control, fault detection and fault‐tolerant controller are designed as a unit in this paper through a supervisor. By introducing a nonlinear estimation error and virtual controller, the sensor failures are separated from the actuator failures in the supervisory control system. It guarantees that the detectability property and matching property of the switched system are satisfied. Firstly, a new extended state observer is designed to match the models of different actuator failures. Secondly, by introducing a virtual controller, the detectability property of the switched system is guaranteed. Finally, a nonlinear estimation error operator is used in the designing of switching logic to guarantee stability of the closed‐loop system with sensor failures. When sensor failures and actuator failures occur, we show that all the states of the closed‐loop system are guaranteed to be bounded. The effectiveness of the fault‐tolerant control is verified by simulation experiments.
1 October 2023 in Journal of Physics: Conference Series
The failure of a long-distance Ultra-high voltage (UHV) Gas Insulated Transmission Line (GIL) during operation will cause great security risks to power transportation. How to locate GIL faults quickly and accurately and further carry out related operation and maintenance work is of great significance to the stable operation of the power grid. Based on this, this paper proposes a two-stage fault location method for UHV GIL based on an ultrasonic sensor network. In this method, ultrasonic sensors are configured in the shell of GIL to form an ultrasonic sensor network and internal faults are located by analyzing the signals collected from the network. The method is divided into two stages: 1) according to the collected signal data, the two sensors closest to the fault point are preliminarily identified, and then the fault point is roughly located, and obtain the data collected by the sensors; 2) we analyze sensor signal data, train and establish a network model based on recurrent neural network RNN for accurate fault location. The verification experiment shows that this method has fast location speed and high location accuracy, and can be effectively applied for quick maintenance, safe operation, and maintenance of GIL.
1 January 2019 in Mathematical Problems in Engineering
An integrated fault estimation and fault‐tolerant control scheme is developed in this paper for dynamic positioning of ships in the presence of an actuator fault. First, an auxiliary derivative output of dynamic positioning ships is constructed in order to satisfy the so‐called observer matching condition, and a high‐gain observer is designed to exactly estimate the auxiliary derivative outputs. Then, a fault‐tolerant controller is developed for dynamic positioning ships based on the iterative learning observer. By means of Lyapunov–Krasovskii stability theory, it is proved that the proposed fault‐tolerant controller is able to estimate the total fault effects and states of ships accurately via the iterative learning observer and also to stabilize the closed‐loop system. In addition, the parameter design of the proposed fault‐tolerant control system can be conveniently solved in terms of linear matrix inequalities. Finally, simulation studies for dynamic positioning ships with actuator faults are carried out, and the results validate the effectivity of the proposed fault‐tolerant control scheme.