1 June 2020 in Surface and Coatings Technology
1 March 2019 in Engineering Failure Analysis
7 September 2017 in Oxidation of Metals
1 November 2021 in Materials Research Express
Excellent resistance to steam oxidation is a key required property for heat-resistant alloys used in next-generation fossil power plants. In order to clarify the degradation mechanism of Ni-Fe-Cr alloys in high temperature steam, four kinds of Ni-Fe-Cr model alloys with various Cr content were prepared and their long-term steam oxidation were investigated at 650 °C and 700 °C. The microstructure and composition of oxide scales were characterized by SEM equipped with EDS, and the oxide phases were identified by XRD. The results showed significant dependence of temperature and Cr content in alloys on the oxidation kinetics, cross-section morphology and elemental section-distribution. For Ni-Fe-Cr alloys with low Cr contents (12∼16 wt.%), the increase of temperature made the oxide scale change from breakaway scale morphology (nodule-crater microstructure with external exfoliation) to protective scale morphology (uniform layer and internal oxidation). For Ni-Fe-Cr alloy with 18wt.% Cr, the effect of temperature was greatly reduced. The oxidation mechanism was discussed from the perspectives of selective oxidation and the effect of alloying elements.
19 March 2019 in Corrosion Engineering, Science and Technology: The International Journal of Corrosion Processes and Corrosion Control
Oxidation behaviour of an austenitic steel HR3C at 620∼650°C for 1000 h in steam with two different levels of dissolved oxygen (DO), 20 ppb and 5 ppm, was investigated by gravimetry, X-ray diffraction and scanning electron microscopy. Results showed that mainly a single-layered (Cr, Mn)2O3 scale was developed. The oxide growth followed near-power kinetics and was accelerated with DO concentration and exposure temperature. At the higher DO concentration, the formation of (Cr, Mn)2O3 with a much smaller size was favoured. Besides, the oxide scale became undulated and interfacial voids formed. Higher exposure temperature resulted in the growth of the (Cr, Mn)2O3 crystals and the change of their morphology from acicular to granular. Fe3O4 nodules and Ni-Cr spinel occurred at 650°C/5 ppm DO. Related oxidation mechanisms were discussed.
30 June 2016 in Corrosion Engineering, Science and Technology: The International Journal of Corrosion Processes and Corrosion Control
Oxidation and oxidation-induced microstructure evolution of CCA617 alloy was studied in pure steam at 750 and 850°C. Results showed that the alloy was oxidised approximately following a parabolic law. Temperature increase greatly promoted the external and internal oxidation. A single (Cr, Mn)2O3 layer with distribution of minor TiO2 and MnCr2O4 formed at 750°C whereas a duplex oxide scale formed at 850°C consisting of a thin MnTiO3 outer layer and a thicker (Cr, Mn)2O3 inner layer. TiO2 and Al2O3 were formed internally especially along grain boundaries. Intragranular Mo-rich M23C6 type carbides were also observed. The carbides dissolved into the matrix as oxidation progressed. Based on detailed compositional and microstructural characterisation of the oxidised alloy, the mechanisms of external and internal oxidation as well as dissolution of the intragranular carbides are presented.