Jin-Hong Jeon

Jin-Hong Jeon

Auto-generated profile, based on publicly available information

Jin-Hong Jeon

Division of Smart Distribution Research Center, Korea Electrotechnology Research Institute, Changwon 51543, Korea

Research Focus & Metrics

Academic Career Length

16Years (2011-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
22 September 2011 in Energies
Verified
Journal Article
Open access
PDF file
JKJong-Yul Kim
Jong-Yul Kim
HKHak-Man Kim
Hak-Man Kim
KCKyeonghee Cho
Kyeonghee Cho
JJJin-Hong Jeon
Jin-Hong Jeon
HCHeung-Kwan Choi
Heung-Kwan Choi
Recently, interest in microgrids, which are composed of distributed generation (DG), distributed storage (DS), and loads, has been growing as a potentially effective clean energy system to mitigate against climate change. The microgrid is operated in the grid-connected mode and the islanded mode according to the conditions of the upstream power grid. The role of the energy storage system (ESS) is especially important to maintain constant the frequency and voltage of an islanded microgrid. For this reason, various approaches for ESS control have been put forth. In this paper, a fuzzy PID controller is proposed to improve the frequency control performance of the ESS. This fuzzy PID controller consists of a fuzzy logic controller and a conventional PI controller, connected in series. The fuzzy logic controller has two input signals, and then the output signal of the fuzzy logic controller is the input signal of the conventional PI controller. For comparison of control performance, gains of each PI controller and fuzzy PID controller are tuned by the particle swam optimization (PSO) algorithm. In the simulation study, the control performance of the fuzzy PID was also tested under various operating conditions using the PSCAD/EMTDC simulation platform.

11 January 2024 in IEEE Transactions on Power Systems
Verified
Journal Article
Closed access
Jin-Oh LeeJin-Oh Lee
Jin-Oh Lee
Yun-Su KimYun-Su Kim
Yun-Su Kim
JJJin-Hong Jeon
Jin-Hong Jeon
This article proposes a new method for determining the optimal placement and sizing of voltage balancers (VBs) in bipolar DC distribution systems. In bipolar DC systems, asymmetric structures, such as distributed generation, loads, and line parameters, can cause voltage imbalances with respect to the poles. Such imbalances can be mitigated by using VBs that balance local positive and negative voltages in a decentralized manner, similar to voltage compensators in conventional AC systems. In this study, a deterministic optimization model is formulated to minimize the installation cost of VBs while maintaining the voltage imbalance within the allowable range. The model is proposed with mixed-integer linear programming using the big-M method and current-injection power flow equations. Subsequently, the uncertainty boundaries of renewable energy sources and loads are incorporated to formulate a robust optimization model as a tri-level optimization problem, which is solved using a column and constraint generation framework. The case study validates the effectiveness of the proposed method for mitigating voltage imbalances with minimum investment cost in bipolar DC distribution systems.

27 September 2019 in Energies
Verified
Journal Article
Open access
PDF file
HAHaesum Ali
Haesum Ali
Akhtar HussainAkhtar Hussain
Akhtar Hussain
Van-Hai BuiVan-Hai Bui
Van-Hai Bui
JJJinhong Jeon
Jinhong Jeon
HKHak-Man Kim
Hak-Man Kim
Integration of demand response programs in microgrids can be beneficial for both the microgrid owners and the consumers. The demand response programs are generally triggered by market price signals to reduce the peak load demand. However, during islanded mode, due to the absence of connection with the utility grid, the market price signals are not available. Therefore, in this study, we have proposed a distributed demand response program for an islanded multi-microgrid network, which is not triggered by market price signals. The proposed distributed demand response program is based on welfare maximization of the network. Based on the welfare function of individual microgrids, the optimal power is allocated to the microgrids of the network in two steps. In the first step, the total surplus power and shortage power of the network is determined in a distributed way by using the local surplus/shortage information of each microgrid, which is computed after local optimization. In the second step, the total surplus of the network is allocated to the microgrids having shortage power based on their welfare functions. Finally, the allocated power amount and the initial shortage amount in the microgrid is used to determine the amount of load to be curtailed. Diffusion strategy is used in both the first and the second steps and the performance of the proposed method is compared with the widely used consensus method. Simulation results have proved the effectiveness of the proposed method for realizing distributed demand response for islanded microgrid networks.

20 June 2020 in Energies
Verified
Journal Article
Open access
PDF file
SHSu-Been Hong
Su-Been Hong
TNThai-Thanh Nguyen
Thai-Thanh Nguyen
JJJinhong Jeon
Jinhong Jeon
HKHak-Man Kim
Hak-Man Kim
This paper proposes a distributed control of the microgrid (MG) system based on the diffusion algorithm. Unlike the existing decentralized strategy that focuses on the economic operation of the MG system, the proposed strategy performs secondary frequency regulation in addition to the optimization of the MG system. The hierarchical control technique is employed in this study, where the primary layer is responsible for power control and the secondary layer is responsible for the frequency control and economic operation of the MG system. A tested MG system with four distributed generations (DGs) is considered. Three types of communication topologies are evaluated in this study, which are line, ring, and full topologies. The proposed controller is compared to the conventional consensus controller to show the effectiveness of the proposed diffusion controller. Simulation results show that the proposed diffusion strategy improves the convergence speed of the distributed control, resulting in the improvement of power responses and frequency quality of the MG system. The tested system is implemented in the MATLAB/Simulink environment to show the feasibility of the proposed diffusion controller.

17 December 2021 in Energies
Verified
Journal Article
Open access
PDF file
JHJihui Hwang
Jihui Hwang
YOYun-Sik Oh
Yun-Sik Oh
JSJin-Uk Song
Jin-Uk Song
JAJae-Guk An
Jae-Guk An
JJJin-Hong Jeon
Jin-Hong Jeon
The rigidity of information technology (IT) has been hindering the development of various businesses regarding energy management systems (EMSs) of power networks, although this area has become more diversified, resulting in changes of elements in the systems due to the introduction of renewable energy (RE) and the new energy industry. In order to effectively accommodate these changes, EMSs should be developed in a structure with a standard-based interface, which can secure interoperability between components in the EMS. In previous studies, the common information model (CIM) proposed by IEC TC57 has been utilized for developing EMSs of power networks, but there are gaps between the existing CIM and an information model for the EMSs of carbon-free island microgrids (MGs), which are a newly introduced form of power network covering multiple islands for reducing carbon emissions. This paper proposes a CIM-based software platform for a carbon-free island MG-EMS to efficiently operate the power network and secure interoperability between components in the MG-EMS. Concerning service restoration of the power network, use cases and business objects representing information exchanged between the components in the EMS are derived, and the existing CIM is extended based on the results of the gap analysis in order to provide necessary information on the MG-EMS. The validity of the proposed platform is verified by exchanging payloads between components in the MG-EMS based on the profile extracted from the extended CIM. Furthermore, the performance of the proposed platform regarding data size and speed of data exchange is presented. Based on the case study results, it is concluded that the proposed platform based on the extended CIM can exchange data between the components in the MG-EMS, achieving reasonable data size and speed of data exchange with the help of the interoperability between components in the carbon-free island MG-EMS.