19 April 2022 in IEEE Open Journal of Antennas and Propagation
Millimeter-wave (mmWave) communications promise Gigabit/s data rates thanks to the availability of large swaths of bandwidth between 10-100 GHz. Although cellular operators prefer the lower portions of the spectrum due to popular belief that propagation there is more favorable, the measurement campaigns to confirm this - conducted by ten organizations thus far - report conflicting results. Yet, it is not clear whether the conflict can be attributed to the channel itself - measured in different environments and at different center frequencies - or to the differences in the organizations' channel sounders and sounding techniques. In this paper, we propose a methodology to measure mmWave frequency dependence, using the 26.5-40 GHz band as an example. The methodology emphasizes calibration of the equipment so that the measurement results represent the channel alone (and not the channel coupled with the channel sounder). Our results confirm that free-space propagation is indeed frequency invariant - a well understood phenomena but to our knowledge reported nowhere else at mmWave to date. More interestingly, we found that specular paths - the strongest after the line-of-sight path and so pivotal to maintaining connectivity during blockage - are the least invariant compared to weaker diffracted and diffuse paths.
2 June 2021 in IEEE Transactions on Antennas and Propagation
A new comparison-to-reference performance verification technique compares an ${E}$ -band channel-sounder (CS) and reference vector network analyzer (VNA) measurements of the same controlled, static channel. This new technique reduces the number of inaccurate assumptions that exist in other methods providing a stronger verification of the CS hardware and processing performance. This technique compares the CS and VNA-derived channel metrics from these measurements. Using mechanical switches, we established a controlled, static RF channel. The VNA has a comprehensive uncertainty analysis that propagates systematic and random uncertainties through to the power delay profiles. The method is suitable for millimeter-wave CS hardware with removable antennas.
4 March 2019 in IEEE Transactions on Antennas and Propagation
6 December 2022 in IEEE Antennas and Propagation Magazine
This year, the annual IEEE International Symposium on Antennas and Propagation and U.S. National Committee for the International Union of Radio Science Radio Science Meeting was held in Denver, CO, USA, on 10–15 July. This conference was special because it was the first in-person conference after the two virtual conferences, in 2020 and 2021, due to the COVID-19 pandemic. Many students, Young Professionals (YPs), engineers, researchers, and professors met in person. The IEEE Antennas and Propagation Society (AP-S) YPs Committee (YPC) [1] conducted important educational and networking activities at the conference. AP-S YPs ambassadors [2] led the way in the development of several new YPs activities, establishing them as an inspirational influence for the Society. Highlights of the YPs activities ( Figure 1 ) are summarized in the following.
20 May 2021 in IEEE Transactions on Instrumentation and Measurement
We describe a mathematical framework for evaluating timing offset and timing noise in channel sounders based on a second-order deterministic model and a stochastic metric based on the Allan deviation. Using this framework, we analyze the timing offset and noise for a 1–6-GHz correlation-based channel sounder that uses rubidium (Rb) clocks to provide a common timebase between the transmitter (Tx) and receiver (Rx). We study timing behavior in three clock-distribution configurations. In the “untethered” configuration, the Tx and Rx each have an Rb clock, and no physical timing cable is connected between the clocks. In the “tethered” configuration, a coaxial cable synchronizes timing between the two separate clocks. Finally, a benchmark “single-clock” configuration is used where a single Rb clock drives the Tx and Rx.