21 January 2020 in Scientific Reports
The amount of Paper Board Mill Effluent Treatment Plant Sludge (PBM-ETPS) dumped from paper mills are huge and its conversion into hydrochar for the purpose of energy has broad prospects. This study investigated the optimum conditions for the production of PBM-ETPS derived hydrochar (PBM-ETPSH) through Reponse Surface Methodology (RSM) for more surface area and pore volume with minimal hydrogen to carbon (H/C) and oxygen to carbon (O/C) ratios. The PBM-ETPSH had higher heating value (HHV) of 18.39 MJ kg−1 with fixed carbon percentage of 15.6. Our results showed a reduction in H/C (35.05%) and O/C (43.7%) ratios confirming the coalification of optimized PBM-ETPSH. Thermogravimetric investigations of blending PBM-ETPSH with coal in 1:1 ratio increased its HHV to 22.25 MJ kg−1 making it suitable as an energy alternative for paper mills.
20 November 2020 in International Journal of Environmental Analytical Chemistry
Activated carbon produced from coconut shells has been gaining interest in wastewater treatment as a potential carbon source for adsorption with desired porosity, surface area, and stability requirements. Acid activation has been preferred for activated carbon production due to its superiority over adsorption of malachite green dye. This study involved in the acid activation of coconut shell derived carbon and its characterisation was performed to study the surface functionalities, thermal stability, textural and structural morphologies. The activated carbon was used for the adsorption of malachite green dye from aqueous solutions and with a special insight by varying contact time (20–220 min) and initial dye concentration (20–80 mg L−1) for adsorption study. Phosphoric acid-activated carbon has shown maximum adsorption capacity (Xm) of 32.787 mg g−1 at initial malachite dye concentration of 20 mg L−1 after 3 hours. All the adsorbents followed Freundlich isotherm with intra particle diffusion model as the rate-limiting step.
5 February 2021 in RSC Advances
Hydrochar, a hydrothermally carbonized product, has gained attention recently as an adsorbent, among its wide environmental applications. In this study, sludge from the paper recycling industry, having a lower pollution load, was used to produce hydrochar, followed by pre-activation and post-activation using KOH. Characterizations were performed for structural morphology (SEM and TEM), molecular functionalities (FTIR) and textural features (BET surface area). Furthermore, Response Surface Methodology (RSM) was used to optimize the adsorption parameters for the removal of orthophosphate with different hydrochars. This study aimed at a low-cost, waste-to-wealth, and negative emission technology for simultaneous solid waste management and orthophosphate removal in aqueous solution. It was predicted from the adsorption experiment that an orthophosphate dose of 100 mg L−1 at substrate pH 5.11 will result in the adsorption of 9.59 mg orthophosphate per g of post-activated hydrochar after 28.6 h, which was validated using further confirmation study.
5 July 2024 in Biomass and Bioenergy
10 June 2019 in International Journal of Current Microbiology and Applied Sciences
31 August 2026 in SSRN Electronic Journal
Peatlands are critical ecosystems on earth, holding the largest natural terrestrial carbon stock (30% of soil carbon) and sequestering around 0.4 billion tonnes of CO2 annually. Despite their ecological significance, anthropogenic impacts have rendered peatlands fragile and affected their ecosystem services. In Northern Ireland (NI), around 86% of peatlands are reported to be degraded. For instance, the study area Garron plateau, the largest blanket bog in NI has three different types of peatland characteristic: actively accumulating, degraded and restored areas. Research to identify and assess indicators of successful restoration strategies have been fragmented i.e. (hydro)-geological/chemical/microbial analyses. Here, we combined geochemical (pH, FTIR, TGA and XRD) and microbial ecology (bacteria and archaea) characterisation to determine baseline data and establish an integrated marker approach as a proxy for a better understanding of peatland degradation and restoration. The thermo-gravimetric parameters (weight loss patterns) and humification indices from FTIR spectroscopy (peak shifts) revealed that the active peat has started to degrade, and the resilience provided by the restoration projects away from degradation. Molecular ecology revealed the abundance of methanogenic communities in active peat, methanotrophic communities in degraded peat and, a mix of methanotrophic and chemotrophic communities in restored peat. Multivariate statistics through CCA confirmed the interdependence and clustering of geochemistry variables and microbial abundance, indicating a closed loop biogeochemical cycling within the native microbes. Our integrated tool approach posits a future comprehensive spatio-temporal analysis could aid in developing a predictive framework to map and mitigate the climate change impacts in these vulnerable peatland ecosystems.