Experiments have been conducted in a large oscillatory flow tunnel to investigate the effects of acceleration skewness on oscillatory boundary layer flow over fixed beds. As well as enabling experimental investigation of the effects of acceleration skewness, the new experiments add substantially to the relatively few existing detailed experimental datasets for oscillatory boundary layer flow conditions that correspond to full-scale sea wave conditions. Two types of bed roughness and a range of high-Reynolds-number, $\mathit{Re}\ensuremath{\sim} O(1{0}^{6} )$ , oscillatory flow conditions, varying from sinusoidal to highly acceleration-skewed, are considered. Results show the structure of the intra-wave velocity profile, the time-averaged residual flow and boundary layer thickness for varying degrees of acceleration skewness, $\ensuremath{\beta} $ . Turbulence intensity measurements from particle image velocimetry (PIV) and laser Doppler anemometry (LDA) show very good agreement. Turbulence intensity and Reynolds stress increase as the flow accelerates after flow reversal, are maximum at around maximum free-stream velocity and decay as the flow decelerates. The intra-wave turbulence depends strongly on $\ensuremath{\beta} $ but period-averaged turbulent quantities are largely independent of $\ensuremath{\beta} $ . There is generally good agreement between bed shear stress estimates obtained using the log-law and using the momentum integral equation, and flow acceleration skewness leads to high bed shear stress asymmetry between flow half-cycles. Turbulent Reynolds stress is much less than the shear stress obtained from the momentum integral; analysis of the stress contributors shows that significant phase-averaged vertical velocities exist near the bed throughout the flow cycle, which lead to an additional shear stress, $\ensuremath{-} \rho \tilde {u} \tilde {w} $ ; near the bed this stress is at least as large as the turbulent Reynolds stress.
Open Access funded by Engineering and Physical Sciences Research Council Under a Creative Commons license Acknowledgements This work is part of the SANTOSS project (‘SANd Transport in OScillatory flows in the Sheet-flow regime’) funded by the UK's EPSRC (GR/T28089/01) and STW in The Netherlands (TCB.6586). JW acknowledges Deltares strategic research funding under project number 1202359.09. Richard Soulsby is gratefully acknowledged for valuable discussions and feedback on the formula during the SANTOSS project.Peer reviewedPostprin
A large‐scale wave flume experiment has been carried out involving a T = 4 s regular wave with H = 0.85 m wave height plunging over a fixed barred beach profile. Velocity profiles were measured at 12 locations along the breaker bar using LDA and ADV. A strong undertow is generated reaching magnitudes of 0.8 m/s on the shoreward side of the breaker bar. A circulation pattern occurs between the breaking area and the inner surf zone. Time‐averaged turbulent kinetic energy (TKE) is largest in the breaking area on the shoreward side of the bar where the plunging jet penetrates the water column. At this location, and on the bar crest, TKE generated at the water surface in the breaking process reaches the bottom boundary layer. In the breaking area, TKE does not reduce to zero within a wave cycle which leads to a high level of “residual” turbulence and therefore lower temporal variation in TKE compared to previous studies of breaking waves on plane beach slopes. It is argued that this residual turbulence results from the breaker bar‐trough geometry, which enables larger length scales and time scales of breaking‐generated vortices and which enhances turbulence production within the water column compared to plane beaches. Transport of TKE is dominated by the undertow‐related flux, whereas the wave‐related and turbulent fluxes are approximately an order of magnitude smaller. Turbulence production and dissipation are largest in the breaker zone and of similar magnitude, but in the shoaling zone and inner surf zone production is negligible and dissipation dominates.