10 April 2025 in Solar RRL
This study presents results of an intercomparison of indoor photovoltaics (PVs) among seven metrological institutes. Three types of solar cells were measured; organic and amorphous silicon cells representing current indoor products in the market and a reference solar cell. Three different light sources—AM1.5G, International Commission of Illumination Standard Illuminant A, and light‐emitting diodes (LED) L41—were used at illuminance levels 100–2000 lx. Each laboratory reported short‐circuit current as mandatory. Open‐circuit voltage, maximum power, and differential spectral responsivity were reported where possible. Measurements revealed notable discrepancies. At the 1000 lx level, best agreement of 7% as standard deviation was achieved for the amorphous silicon cell using Standard Illuminant A. Similarly, the worst agreement of 37% was found for the reference cell using AM1.5G. Measurement methods varied across the laboratories. Some participants used lamps for Standard Illuminant A and LED L41. These measurements were generally in agreement but deviated from measurements with LED‐based solar simulators, due to differences in measurement geometry, spectral properties, and treatment of infrared. Different illuminance measurement approaches, using either calibrated reference cells or luxmeters, further impacted consistency. This study highlights need for harmonized procedures to support reliable performance assessment of indoor PVs and gives recommendations to account for in standards.
11 January 2021 in Metrologia
Main text: The EURAMET.PR-S5 intercomparison of the short circuit current of reference solar cells at standard test conditions was carried out as star type comparison. In total 6 participants with seven facilities took part, 1 from Europe (PTB/Germany with two facilities: the established DSR facility as pilot lab and the new Laser-DSR facility as participant) and 5 outside Europe (NIM/China, VNIIOFI/Russia, KRISS/South Korea, A-STAR/Singapore, ITRI/Chinese Taipei). Therefore, this comparison can be considered as a worldwide one as all NMIs world-wide that had built up facilities for the primary ISTC-calibration of reference solar cells when the measurements started, participated. For the calculation of the reference value of the supplementary comparison no participant had to be excluded and the used weighted mean with cut-off has been supported by all participants. The unilateral Degrees of Equivalence (DoE) calculated for each participant are fully 100 % consistent with their standard uncertainties. The largest En-value is 0.61 and therefore significant smaller than 1. The chi-square test is fully satisfied with 2.09 < χ 2 (5) = 11.07. Thus, the DSR method is highly suitable for the calibration of reference solar cells according to the short circuit current at standard test conditions. To reach the main text of this paper, click on Final Report . Note that this text is that which appears in Appendix B of the BIPM key comparison database kcdb.bipm.org/ . The final report has been peer-reviewed and approved for publication by the CCPR, according to the provisions of the CIPM Mutual Recognition Arrangement (CIPM MRA).
27 April 2026 in Results in Engineering