Usman Asad

Usman Asad

Auto-generated profile, based on publicly available information

Usman Asad

Department of Mechanical, Automotive & Materials Engineering, University of Windsor, 401 Sunset Avenue, Windsor, ON N9B 3P4, Canada

Research Focus & Metrics

Academic Career Length

15Years (2012-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 October 2015 in Journal of Engineering for Gas Turbines and Power
Verified
Journal Article
Closed access
PDF file
UAUsman Asad
Usman Asad
MZMing Zheng
Ming Zheng
DTDavid Ting
David Ting
JTJimi Tjong
Jimi Tjong
Homogeneous charge compression ignition (HCCI) combustion in diesel engines can provide cleaner operation with ultralow NOx and soot emissions. While HCCI combustion has generated significant attention in the last decade, however, till date, it has seen very limited application in production diesel engines. HCCI combustion is typically characterized by earlier than top-dead-center (pre-TDC) phasing, very high-pressure rise rates, short combustion durations, and minimal control over the timing of the combustion event. To offset the high reactivity of the diesel fuel, large amounts of exhaust gas recirculation (EGR) (30–60%) are usually applied to postpone the initiation of combustion, shift the combustion toward TDC, and alleviate to some extent, the high-pressure rise rates and the reduced energy efficiency. In this work, a detailed analysis of HCCI combustion has been carried out on a high-compression ratio (CR), single-cylinder diesel engine. The effects of intake boost, EGR quantity/temperature, engine speed, injection scheduling, and injection pressure on the operability limits have been empirically determined and correlated with the combustion stability, emissions, and performance metrics. The empirical investigation is extended to assess the suitability of common alternate fuels (n-butanol, gasoline, and ethanol) for HCCI combustion. On the basis of the analysis, the significant challenges affecting the real-world application of HCCI are identified, their effects on the engine performance quantified, and possible solutions to overcome these challenges explored through both theoretical and empirical investigations. This paper intends to provide a comprehensive summary of the implementation issues affecting HCCI combustion in diesel engines.

24 September 2012 in International Journal of Engine Research
Verified
Journal Article
Closed access
UAUsman Asad
Usman Asad
MZMing Zheng
Ming Zheng
The pursuit for higher efficiency and ultra-low exhaust emissions from diesel engines requires the combustion process to be precisely controlled so as to minimize departures from the intended engine operation. The combustion control system must be able to perform corrective actions on a cycle-by-cycle basis, with a robust feedback on the combustion process. The combustion phasing, commonly represented by the crank angle of 50% heat release and derived from the measured cylinder pressure data, shows a strong correlation to the efficiency and the engine-out nitrogen oxide emissions. To accurately estimate the combustion phasing from the derived heat-release rate, the authors previously introduced and experimentally validated a computationally efficient diesel pressure departure ratio algorithm, against selected cases of boost, engine load and exhaust gas recirculation. In this work, the formulation of the pressure departure ratio algorithm is presented in detail along with its implementation to enable combustion control during both transient and steady-state engine operations. Engine tests demonstrate that the algorithm was effective in stabilizing the combustion process on a cycle-by-cycle basis for a range of engine speeds, load and exhaust gas recirculation, which included conventional and low-temperature diesel combustion modes.

1 January 2012 in The Proceedings of the International symposium on diagnostics and modeling of combustion in internal combustion engines
Verified
Journal Article
Closed access
UAUsman Asad
Usman Asad
MZMing Zheng
Ming Zheng
JTJimi Tjong
Jimi Tjong
MWMeiping Wang
Meiping Wang