23 June 2026 in SSRN Electronic Journal
Maximizing containment of gases and vapors in composite pipelines is critical for long‑term, reliable operation. The selection of polymeric barrier materials for liners therefore requires understanding how polymer chemistry and morphology control gas transport. In practice, commercial liner grades may contain proprietary additives, and qualification demands that permeation rates measured on disc specimens cut from the liner wall be consistent with measurements on full pipe sections with connectors. In addition, estimates are needed for the contribution of reinforcement layers to radial and axial permeation towards venting points in different piping configurations.This work applies a multiscale approach to characterize permeation of CO₂, H₂S and CH₄ mixtures through reinforced polymer composite pipes for oil and gas transportation manufactured with different liner chemistries. The methodology, as shown in Figure 1, integrates coupon‑scale measurements of individual‑gas permeation over a broad temperature range with finite‑element modelling and full‑scale pipe tests, thereby reducing uncertainties in long‑term predictions of pipe integrity, fugitive emissions and in‑service venting requirements. Coupon data are used to calibrate the numerical model, which is then validated against whole‑pipe experiments and extended to quantify the contribution of the reinforcement layer to overall permeation.The approach is demonstrated on unbonded glass‑reinforced thermoplastic composite pipes with polyethylene (PE) and polyphenylene sulfide (PPS) liners. Experiments at 103 barg and 82 °C show that upgrading the liner from PE to PPS markedly decreases gas permeation at pipe level, with approximate reductions of 30‑fold for CH₄, 20‑fold for H₂S and 10‑fold for CO₂, in agreement with numerical predictions.