3 April 2013 in Scientific Reports
Metallic nanoparticles (NPs) have received recently considerable interest of photonic and photovoltaic communities. In this work, we report the optoelectronic properties of gold NPs (Au-NPs) obtained by depositing very thin gold layers on glass substrates through thermal evaporation electron-beam assisted process. The effect of mass thickness of the layer was evaluated. The polycrystalline Au-NPs, with grain sizes of 14 and 19 nm tend to be elongated in one direction as the mass thickness increase. A 2 nm layer deposited at 250°C led to the formation of Au-NPs with 10-20 nm average size, obtained by SEM images, while for a 5 nm layer the wide size elongates from 25 to 150 nm with a mean at 75 nm. In the near infrared region was observed an absorption enhancement of amorphous silicon films deposited onto the Au-NPs layers with a corresponding increase in the PL peak for the same wavelength region.
29 September 2011 in Energy & Environmental Science
Nanostructured silicon single junction thin film solar cells were deposited on commercial red clay roof tiles with engobe surfaces and earthenware wall tiles with glazed surfaces, with a test area of 24 mm2. We studied the influence of the type of substrate tile, back contact, buffer layer and SiOx passivation layer on the optoelectronic performance of the solar cells. Despite the fact that typical micrometre-sized defects on the surfaces of the tiles and the porous nature of the ceramic substrates make deposition of homogeneous thin films on them quite challenging, we have been able to achieve a cell efficiency of 5% and a quantum efficiency of 80% on non-fully optimized cells on commercial tiles. The method is industrially employable utilizing pre-existing plasma-enhanced chemical vapour deposition technologies. The cost-effectiveness and industrial feasibility of the technique are discussed. Our study shows that photovoltaic tiles can combine energy generation with architectural aesthetics leading to significant implications for advancement in building integrated photovoltaics.
11 January 2002 in Physica Status Solidi (b)
12 March 2001 in Physica Status Solidi (b)
1 May 2008 in Journal of Non-Crystalline Solids
1 June 2003 in Optics and Spectroscopy
Efficient photoluminescence (PL) up-conversion in CdSe/ZnS quantum dots prepared by an organometallic approach is reported. It is demonstrated that the efficiency of photon energy up-conversion and the magnitude of the spectral shift can be controlled by (i) the thickness of the ZnS layers, (ii) the temperature dependence of the excited-state absorption coefficient, and (iii) the dependence on the excitation intensity. From the analysis of the experimental data, it is proposed that intrinsic gap states are involved as intermediate states in the PL up-conversion, rather than nonlinear two-photon absorption or Auger processes.