Transport properties and structural features of a number of already known and new types of polymeric membranes in desalination of aqueous salt solutions by membrane distillation and pervaporation were studied. The possibility of obtaining distilled water in a single stage by pervaporation from dilute or concentrated aqueous salt solutions was examined for the example of membranes fabricated from celluloses of varied origin (wood, cotton, bacterial).
New composite hydrogels based on cellulose and poly(acrylamide) have been synthesized via radical polymerization of acrylamide in cellulose swollen in a reaction solution. In this study, both a plant form of cellulose and a bacterial form—that cultivated by Acetobacter xylinum bacteria—were used. The behavior of synthesized hydrogels during swelling in water, as well as the behavior of the samples swollen at equilibrium during deformation under uniaxial compression under various test conditions, have been studied. A comparative analysis of the main mechanical characteristics of hydrogels and the appropriate data for various types of articular cartilage, one of which—rabbit knee meniscus—has been tested in this study, has been performed. An average-strength hydrogel is very close to articular cartilage in all mechanical characteristics. The degrees of loading at the highest compression deformations observed during the function of joint cartilage (30–50%) is in the range 4–12 MPa for this hydrogel, and the average values of the compression modulus in the deformation ranges of 10–15 and 25–30% are 8.8 and 23.7 MPa, respectively. The behavior of hydrogels and rabbit meniscus under cyclic compression with the amplitude of 50% has been studied. Hydrogels and meniscus under this test conditions demonstrate clear viscoelastic behavior, evidenced by noticeable hysteresis for the first cycle and a decrease in the value of the maximum load with an increase in the number of cycles. Structural features of hydrogels, which can affect the behavior of the hydrogels under study, have been considered. On the whole, the results demonstrate the possibility of modeling the mechanical behavior of cartilage with the use of hydrogels of this type.
The data are presented on optimization of cellulose synthesis by Acetobacter xylinum (strain VKM V-880) and the structural characteristics of A. xylinum cellulose gel film synthesized during static cultivation. The structural changes caused by the removal of water from gel films are established and the structural organization of macromolecular chains in cellulose A. xylinum is studied.