26 June 2013 in BioMedical Engineering OnLine
Introduction: Model-based methods can be used to characterise patient-specific condition and response to mechanical ventilation (MV) during treatment for acute respiratory distress syndrome (ARDS). Conventional metrics of respiratory mechanics are based on inspiration only, neglecting data from the expiration cycle. However, it is hypothesised that expiratory data can be used to determine an alternative metric, offering another means to track patient condition and guide positive end expiratory pressure (PEEP) selection.Methods: Three fully sedated, oleic acid induced ARDS piglets underwent three experimental phases. Phase 1 was a healthy state recruitment manoeuvre. Phase 2 was a progression from a healthy state to an oleic acid induced ARDS state. Phase 3 was an ARDS state recruitment manoeuvre. The expiratory time-constant model parameter was determined for every breathing cycle for each subject. Trends were compared to estimates of lung elastance determined by means of an end-inspiratory pause method and an integral-based method. All experimental procedures, protocols and the use of data in this study were reviewed and approved by the Ethics Committee of the University of Liege Medical Faculty.Results: The overall median absolute percentage fitting error for the expiratory time-constant model across all three phases was less than 10 %; for each subject, indicating the capability of the model to capture the mechanics of breathing during expiration. Provided the respiratory resistance was constant, the model was able to adequately identify trends and fundamental changes in respiratory mechanics.Conclusion: Overall, this is a proof of concept study that shows the potential of continuous monitoring of respiratory mechanics in clinical practice. Respiratory system mechanics vary with disease state development and in response to MV settings. Therefore, titrating PEEP to minimal elastance theoretically results in optimal PEEP selection. Trends matched clinical expectation demonstrating robustness and potential for guiding MV therapy. However, further research is required to confirm the use of such real-time methods in actual ARDS patients, both sedated and spontaneously breathing.
1 January 2014 in Computational and Mathematical Methods in Medicine
Background. Respiratory mechanics models have the potential to guide mechanical ventilation. Airway branching models (ABMs) were developed from classical fluid mechanics models but do not provide accurate models ofin vivobehaviour. Hence, the ABM was improved to include patient-specific parameters and better model observed behaviour (ABMps).Methods. The airway pressure drop of the ABMps was compared with the well-accepted dynostatic algorithm (DSA) in patients diagnosed with acute respiratory distress syndrome (ARDS). A scaling factor (α) was used to equate the area under the pressure curve (AUC) from the ABMps to the AUC of the DSA and was linked to patient state.Results. The ABMps recorded a medianαvalue of 0.58 (IQR: 0.54–0.63; range: 0.45–0.66) for these ARDS patients. Significantly lowerαvalues were found for individuals with chronic obstructive pulmonary disease ().Conclusion. The ABMps model allows the estimation of airway pressure drop at each bronchial generation with patient-specific physiological measurements and can be generated from data measured at the bedside. The distribution of patient-specificαvalues indicates that the overall ABM can be readily improved to better match observed data and capture patient condition.
1 January 2015 in IFAC-PapersOnLine
Endogenous insulin (UN) secreted by pancreatic β-cells plays a leading role in glucose homeostasis. Pathological changes in UN can enable early diagnosis of metabolic dysfunction before the emergence of type 2 diabetes. The dynamic insulin sensitivity and secretion test (DISST) is a dynamic test that is able to quantify participant-specific insulin sensitivity (SI) values and UN profiles. Like most studies, the DISST uses direct inversion of C-peptide concentration measurements to quantify a UN profile which relies on the assumption that insulin and C-peptide are equimolarly secreted from β-cells. This study develops a proportional-derivative (PD) control model that defines UN as a function of glucose concentration to provide further insight and modeling capability for this prediabetic state. Results show that individuals with normal glucose tolerance (NGT) tend to have higher gain ratio compared to individuals with impaired fasting glucose (IFG) with median values of 19.11 and 2.79 min, respectively. In particular, the main difference between the UN profiles of NGT and IFG group lies within the derivative gain (σ0), specifically in first phase secretion (U1). A higher value of σO is needed in response to an abrupt increase in plasma glucose level. This proposed model offers model simplicity as well as a link between insulin secretion and glucose concentration that is able to provide more information in determining each participant's glycemic condition.
1 January 2014 in IFAC Proceedings Volumes