1 June 2020 in Journal of Photochemistry and Photobiology A: Chemistry
12 January 2018 in New Journal of Chemistry
Herein, we report the synthesis and characterization of Cu3N nanocrystals using two single-source precursors, bis (pyrrole-2-carbalpropyliminato) Cu(ii) (PPC) and Cu(NO3)2·3H2O.
1 October 2018 in Applied Surface Science
10 September 2020 in RSC Advances
LMLerato F. E. Machogo-Phao
Lerato F. E. Machogo-Phao
+3
To study the effect of time on the colloidal synthesis of Cu 3 N nanoparticles, copper( ii ) nitrate was thermally decomposed at 260 °C for up to 60 min in octadecylamine as a stabilizing ligand.
14 March 2019 in New Journal of Chemistry
Noble transition metal chalcogenide gold selenide is a relatively unexplored layered material. Herein, we report on the synthesis and characterization of polymorphic mixed-valence AuSe (Au1+Au3+Se2) by varying the sequence of the addition of the precursors in a colloidal synthesis. Despite the variations, all produced materials showed the co-existence of α- and β-AuSe. Although both polymorphs were observed, XRD showed that the addition of the gold precursor at higher temperatures resulted in α-AuSe being the dominant phase while the addition at lower temperatures resulted in β-AuSe being preferred. The crystal structures of both α- and β-AuSe consist of repeating units of a linearly bonded Au1+ ion to two Se atoms and a Au3+ ion bonded to four Se atoms in a square planar geometry. The Au4f core level spectrum of XPS showed only the Au+1 oxidation state, however, using the Se3d core level spectrum, the formation of AuSe (Au1+Au3+Se2) was evident. Using DFT calculations, the Raman spectra of α- and β-AuSe were simulated and only the square planar geometry was found to be Raman active. The square planar geometry (Au3+Se4)− ions belonging to the D4h point group produced three Raman active vibrational modes, namely, a symmetric stretch (A1g), a planar bend (B1g) and an asymmetric stretch (B2g) for α-AuSe as well as A1g and B1g for β-AuSe. Experimentally, all samples showed Raman vibrational lines from both phases. Moreover, Raman spectroscopy confirmed the presence of Au3+ in AuSe which was not detected using XPS. From the TEM and SEM results, it was evident that the morphologies of the predominantly α-AuSe samples were nanobelts while the predominantly β-AuSe samples showed plate-like structures. The predominantly α-AuSe samples showed a broad absorption band with a maximum at 853 nm while the predominantly β-AuSe samples showed evidence of absorption however with no defined excitonic peak.