1 June 2019 in Marine Geology
8 August 2017 in Geophysical Journal International
Convergence in the eastern Mediterranean of oceanic Nubia with Anatolia and the Aegean is complex and poorly understood. Large volumes of sediment obscure the shallow structure of the subduction zone, and since much of the convergence is accommodated aseismically, there are limited earthquake data to constrain its kinematics. We present new source models for recent earthquakes, combining these with field observations, published GPS velocities and reflection-seismic data to investigate faulting in three areas: the Florence Rise, SW Turkey and the Pliny and Strabo Trenches. The depths and locations of earthquakes reveal the geometry of the subducting Nubian plate NE of the Florence Rise, a bathymetric high that is probably formed by deformation of sediment at the surface projection of the Anatolia–Nubia subduction interface. In SW Turkey, the presence of a strike-slip shear zone has often been inferred despite an absence of strike-slip earthquakes. We show that the GPS-derived strain-rate field is consistent with extension on the orthogonal systems of normal faults observed in the region and that strike-slip faulting is not required to explain observed GPS velocities. Further SW, the Pliny and Strabo Trenches are also often interpreted as strike-slip shear zones, but almost all nearby earthquakes have either reverse-faulting or normal-faulting focal mechanisms. Oblique convergence across the trenches may be accommodated either by a partitioned system of strike-slip and reverse faults or by oblique slip on the Aegean–Nubia subduction interface. The observed late-Quaternary vertical motions of coastlines close to the subduction zone are influenced by the interplay between: (1) thickening of the material overriding the subduction interface associated with convergence, which promotes coastal uplift; and (2) subsidence due to extension and associated crustal thinning. Long-wavelength gravity data suggest that some of the observed topographic contrasts in the eastern Mediterranean are supported by mantle convection. However, whether the convection is time dependent and whether its pattern moves relative to Nubia are uncertain, and its contribution to present-day rates of vertical coastal motions is therefore hard to constrain. The observed extension of the overriding material in the subduction system is probably partly related to buoyancy forces arising from topographic contrasts between the Aegean, Anatolia and the Mediterranean sea floor, but the reasons for regional variations are less clear.
1 February 2022 in Bulletin of the Seismological Society of America
We present an earthquake simulator for New Zealand. It uses the Rate-and-State Earthquake Simulator engine based on approximations of the rate-and-state friction equations. The full set of faults considered in the most recent New Zealand national seismic hazard maps are included in the simulator. New simulator methods are introduced that allow for the inclusion and interaction between upper plate faults and a subduction interface fault below them. The simulator generates sequences of complex slip events and a catalog of finite ruptures hundreds of thousands of years in length. Results from the simulator are evaluated through statistical testing and comparison with geological and geophysical observations. These evaluations include a spatial comparison against historical earthquakes, a comparison against rates of events in the instrumental catalog, and a comparison against scaling relations. Consistency of the model with these measures is generally found, though some differences with productivity is noted, due to incomplete modeling of subducting slab features like geodetically inferred spatially dependent creep and dense faulting in Bay of Plenty faults. Significant emergent aspects of the resulting synthetic catalog are discussed. These include substantial variability over instrumental catalog timescales, clustering of large events in space and time, and spontaneous ruptures that break both the upper crustal faults and subduction interface coseismically. An online repository provides the model output, and an additional site provides python code for reproducing some of the figures in this article and tools for further model output analysis.
6 June 2024 in Earth's Future
Anticipating and managing the impacts of sea‐level rise for nations astride active tectonic margins requires understanding of rates of sea surface elevation change in relation to coastal land elevation. Vertical land motion (VLM) can either exacerbate or reduce sea‐level changes with impacts varying significantly along a coastline. Determining rate, pattern, and variability of VLM near coasts leads to a direct improvement of location‐specific relative sea level (RSL) estimates for coastal hazard risk assessment. Here, we utilize vertical velocity field from interferometric synthetic aperture radar (InSAR) data, calibrated with campaign and continuous Global Navigation Satellite System data, to determine the VLM for the entire coastline of New Zealand. Guided by available knowledge of the seismic cycle, the VLM data infer secular, interseismic rates of land surface deformation. Using the Framework for Assessing Changes to Sea‐level (FACTS), we build probabilistic RSL projections using the same emissions scenarios employed in IPCC Assessment Report 6 and local VLM data at 8,179 sites, thereby enhancing spatial coverage that was previously limited to four tide gauges. We present ensembles of probability distributions of RSL for each scenario to 2150, and for low confidence sea‐level processes to 2300. Where land subsidence is occurring at rates >2 mm/y VLM makes a significant contribution to RSL projections for all scenarios out to 2150. Our approach can be applied to similar locations across the world and has significant implications for adaptation planning, as timing of threshold exceedance for coastal inundation can be brought forward (or delayed) by decades.
7 April 2022 in Geosphere
The complex 2016 MW 7.8 Kaikōura earthquake ruptured >20 faults and caused highly variable uplift and subsidence of an ~110 km stretch of coastline. The earthquake raised questions about fault interactions in regions of oblique convergence and especially subduction to strike-slip transition zones like the Kaikōura region. We integrate 2016 coastal vertical deformation observations with new mapping and dating of Holocene marine terraces to: (1) compare spatial patterns of 2016 coseismic and longer-term vertical motions, (2) investigate possible past multi-fault ruptures or temporal clusters of earthquakes around Kaikōura, and (3) assess the relative contributions of crustal faults and the Hikurangi subduction interface to late Holocene coastal uplift. We identify possible multi-fault ruptures or loose clusters of earthquakes at ca. 850–550 yr B.P. and ca. 350–100 yr B.P. Most (and possibly all) of the Kaikōura coast has been uplifted over the late Holocene; the 25-km-long Parikawa section of coast subsided coseismically in 2016 but appears to be uplifted through reverse slip on an offshore fault. Late Holocene uplift everywhere along the coastline of interest can be attributed to slip on known upper-plate faults; slip on a shallow-dipping (<20°) subduction interface cannot be ruled out but is not required to explain uplift.
5 May 2023 in Science Advances
Surface-rupturing earthquakes can produce fault displacements that abruptly alter the established course of rivers. Several notable examples of fault rupture–induced river avulsions (FIRAs) have been documented, yet the factors influencing these phenomena have not been examined in detail. Here, we use a recent case study from New Zealand’s 2016 Kaikōura earthquake to model the coseismic avulsion of a major braided river subjected to ~7-m vertical and ~4-m horizontal offset. We demonstrate that the salient characteristics of the avulsion can be reproduced with high accuracy by running a simple two-dimensional hydrodynamic model on synthetic (pre-earthquake) and “real” (post-earthquake) deformed lidar datasets. With adequate hydraulic inputs, deterministic and probabilistic hazard models can be precompiled for fault-river intersections to improve multihazard planning. Flood hazard models that ignore present and potential future fault deformation may underestimate the extent, frequency, and severity of inundation following large earthquakes.