The umbilical cable is today an important technology used to control equipment on the seabed in the production of offshore oil in deep and ultra-deep waters. The umbilical is composed of several components, including steel tube for transporting fluids for hydraulic control of equipment in the bed. Such tubes are susceptible to fatigue during their life in umbilical operation. Fatigue strength is influenced by the accumulated plastic strain (APS) undergone by the tubes during the entire manufacturing process until installation/storage on spools. This present study investigated whether the way in which the APS is applied influences the fatigue strength of the tubes. Fatigue test specimens were machined from super duplex umbilical tube, which received 5% of APS by cyclic bending in two different ways: repeated bending and alternating bending. Microstructural and microhardness analyzes were performed on the specimens after fatigue fracture. No significant difference neither in microstructure, nor on the microhardness of the two groups of specimens was found after fatigue fracture. However, the group subjected to alternating plastic strain experienced lower fatigue strength. Therefore, the way in wich the tubes are deformed during manufacture and storage influences their fatigue performance.
20 May 2026 in Journal of Failure Analysis and Prevention
High-carbon steel wires (0.7%C) are widely used in engineering due to their high strength and versatility. Among their various applications, their use under severe conditions, including embrittling environments and fatigue loading, is particularly noteworthy. Wire welding can introduce imperfections and weaken the material, an effect further aggravated by hydrogen-inducing agents. Although butt resistance welding is the most commonly employed technique for wires, it presents several limitations. This study investigates rotary friction welding as an alternative process, evaluating fatigue resistance and hydrogen embrittlement in 5.2 mm diameter wires, in comparison with the conventional resistance welding method. The results showed that friction-welded joints exhibited an approximately 90% increase in fatigue life and effectively eliminated the hydrogen embrittlement susceptibility observed in resistance welds, raising the success rate in testing from 20 to 100%. It is concluded that the rotary friction process reduces the formation of brittle microstructures and provides high resistance to hydrogen embrittlement. Therefore, the adoption of rotary friction welding is recommended for critical applications of high-carbon steel wires subjected to fatigue and hydrogen-susceptible environments.