Mai Yang

Mai Yang

Auto-generated profile, based on publicly available information

Mai Yang

Chaozhou Branch of Chemistry and Chemical Engineering Guangdong Laboratory 1 , Chaozhou 521000, China

Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
29 July 2024 in Journal of Vacuum Science & Technology A
Verified
Journal Article
Closed access
PDF file
QLQizhong Li
Qizhong Li
FLFazhen Liu
Fazhen Liu
MYMai Yang
Mai Yang
TGTenghua Gao
Tenghua Gao
Baifeng JiBaifeng Ji
Baifeng Ji
LZLianmeng Zhang
Lianmeng Zhang
The structure design and optimization of multilayer coatings, which are utilized to surmount the trade-off between hardness and toughness, has been a current hot topic in the field of hard ceramic coatings. Herein, multi-layered TiSiN/AlCrN coatings with a constant and gradient sublayer thickness (Λ, modulation periods) ranging from 20 to 3.8 nm were prepared by the cathodic arc ion plating. The microstructure, mechanical properties, residual stress, and fracture toughness of four gradient structures were investigated systematically. All coatings exhibit a typical FCC crystal structure. In the coating with a monotonous decrease of modulation period (single gradient periodic decreasing structure, G2), the interface between the TiSiN layer and the AlCrN layer transformed from a partially semi-coherent interface at the bottom layers of Λ = 20 nm, to a fully coherent interface at the top layers of Λ = 3.8 nm. The coating with dual-gradient structures (modulation period increases first and then decreases, V2) demonstrated the highest hardness (37.6 ± 1.0 GPa), H/E* and H3/E*2 ratios (0.087 and 0.28 GPa), and bonding strength (75.3 N), as well as lowest friction coefficient (0.34) and wear rate (6.7 × 10−6 mm3/N m). The remarkable resistance to damage and toughness displayed by the V2 structure could be ascribed to its intrinsic capacity for effectively alleviating stress concentration and accommodating incompatibilities during the plastic deformation process. This work offers insights into employing gradient architecture design to enhance the strength and toughness of coatings.

21 October 2022
Verified
Conference Paper
Open access
MYMai Yang
Mai Yang
LQLing Qing
Ling Qing
LWLei Wang
Lei Wang
In order to improve the driving stability of autonomous vehicles when steering lane change to avoid obstacles under high-speed conditions, a vehicle lane change controller based on Fuzzy control and Model predictive control was designed. The controller is based on the MPC algorithm and includes active vehicle steering with controlled front wheel angle as well as a five-polynomial lane-change trajectory model. determine the additional yaw moment needed by using the desired deviation of the yaw speed and its rate of change as the dual inputs to the fuzzy control. to increase the stability of the vehicle's high-speed lane change and proper body attitude. The results of a joint Carsim/Simulink simulation show that the controller improves the stability of the vehicle when steering and lane avoidance is performed at high speeds compared to a conventional model predictive controller.