Herein, we report an atomic layer deposition (ALD) process for Cu2O thin films using copper(II) acetate [Cu(OAc)2] and water vapor as precursors. This precursor combination enables the deposition of phase-pure, polycrystalline, and impurity-free Cu2O thin films at temperatures of 180–220 °C. The deposition of Cu(I) oxide films from a Cu(II) precursor without the use of a reducing agent is explained by the thermally induced reduction of Cu(OAc)2 to the volatile copper(I) acetate, CuOAc. In addition to the optimization of ALD process parameters and characterization of film properties, we studied the Cu2O films in the fabrication of photoconductor devices. Our proof-of-concept devices show that approximately 20 nm thick Cu2O films can be used for photodetection in the visible wavelength range and that the thin film photoconductors exhibit improved device characteristics in comparison to bulk Cu2O crystals.
14 January 2021 in ACS Applied Materials & Interfaces
Slight surface modifications of TiO2(“insignificant” at first glance), such as exposing to reducing or oxidizing agents and deposition of small amounts of a semiconductor material at the surface, may strongly affect the photoactivity of materials.
13 October 2015 in Journal of Vacuum Science & Technology A
Copper(II) oxide thin films were grown by atomic layer deposition (ALD) using bis-(dimethylamino-2-propoxide)copper [Cu(dmap)2] and ozone in a temperature window of 80–140 °C. A thorough characterization of the films was performed using x-ray diffraction, x-ray reflectivity, UV-Vis spectrophotometry, atomic force microscopy, field emission scanning electron microscopy, x-ray photoelectron spectroscopy, and time-of-flight elastic recoil detection analysis techniques. The process was found to produce polycrystalline copper(II) oxide films with a growth rate of 0.2–0.3 Å per cycle. Impurity content in the films was relatively small for a low temperature ALD process.