15 February 2022 in ACS Applied Materials & Interfaces
2 November 2023 in ACS Catalysis
Li-mediated ammonia synthesis is, thus far, the only electrochemical method for heterogeneous decentralized ammonia production. The unique selectivity of the solid electrode provides an alternative to one of the largest heterogeneous thermal catalytic processes. However, it is burdened with intrinsic energy losses, operating at a Li plating potential. In this work, we survey the periodic table to understand the fundamental features that make Li stand out. Through density functional theory calculations and experimentation on chemistries analogous to lithium (e.g., Na, Mg, Ca), we find that lithium is unique in several ways. It combines a stable nitride that readily decomposes to ammonia with an ideal solid electrolyte interphase, balancing reagents at the reactive interface. We propose descriptors based on simulated formation and binding energies of key intermediates and further on hard and soft acids and bases (HSAB principle) to generalize such features. The survey will help the community toward electrochemical systems beyond Li for nitrogen fixation.
2 November 2021 in Analytical Chemistry
20 December 1997 in Journal of Geophysical Research: Atmospheres
Measurements of NO, NOy, O3, and CO were made during NASA's Global Tropospheric Experiment/Pacific Exploratory Mission‐West B (GTE/PEM‐West B) carried out over the western Pacific in February and March 1994. NOx was calculated from NO using a photostationary state model ((NOx)mc). Correlations between these species are presented, and some insights into the sources of NOx and NOy are described. The boundaries between the lower, middle, and upper troposphere have been defined at potential temperatures of 311 K and 328 K, which correspond to the geometric altitudes of about 5 and 9 km at 30°N. Enhancements in the mixing ratios of NOy and CO were observed in the lower and middle troposphere. A positive correlation was found between these two species suggesting that the high NOy values were due to anthropogenic emissions over the continental surface. On the other hand, O3 increased little with increase in CO. As a result, NOy/O3 ratios were higher in air more influenced by pollution. NOy values in 55 and 28% of the air masses sampled in the lower and middle troposphere, respectively, were higher than the clean free tropospheric NOy‐O3 range when O3 values simultaneously observed were used. High (NOx)mc/NOy ratios between 0.15 and 0.3 were found in the boundary layer with relatively low mixing ratios of CO and NOy during the three flights. These air masses were transported from a higher altitude (∼5 km) and a higher latitude (∼50°N) within a few days. The peroxyacetyl nitrate (PAN)/NOy ratios were generally high (∼0.4) in these air masses, and the thermal decomposition of PAN was a probable source of NOx. In the middle troposphere the (NOx)mc mixing ratio did not generally increase with NOy or CO, suggesting that the transport of air masses affected by anthropogenic emissions did not increase the NOx level significantly. In the upper troposphere, very minor effects from the continental surface sources were seen in the CO mixing ratio. By contrast, NOy values in 33% of the air masses were higher than those expected when stratospheric air intrusion is assumed to be a single source of NOy based on NOy‐O3 correlation analyses. This result suggests significant free tropospheric NOy sources, namely exhaust from the aircraft and NO production by lightning activity. In fact, spikes in the (NOx)mc mixing ratios were observed near the aircraft corridor south of Tokyo at an altitude of 10 km. These two free tropospheric NOx sources were considered to be important in determining the levels of the upper tropospheric NOx and NOy during PEM‐West B.
26 April 2021 in Advanced Energy Materials
7 February 2021 in Journal of Applied Electrochemistry
Graphitic materials cannot be applied for the negative electrode of sodium-ion battery because the reversible capacities of graphite are anomalously small. To promote electrochemical sodium-ion intercalation into graphitic materials, the interfacial sodium-ion transfer reaction at the interface between graphitized carbon nanosphere (GCNS) electrode and organic electrolyte solutions was investigated. The interfacial lithium-ion transfer reaction was also evaluated for the comparison to the sodium-ion transfer. From the cyclic voltammograms, both lithium-ion and sodium-ion can reversibly intercalate into/from GCNS in all of the electrolytes used here. In the Nyquist plots, the semi-circles at the high frequency region derived from the Solid Electrolyte Interphase (SEI) resistance and the semi-circles at the middle frequency region owing to the charge-transfer resistance appeared. The activation energies of both lithium-ion and sodium-ion transfer resistances were measured. The values of activation energies of the interfacial lithium-ion transfer suggested that the interfacial lithium-ion transfer was influenced by the interaction between lithium-ion and solvents, anions or SEI. The activation energies of the interfacial sodium-ion transfer were larger than the expected values of interfacial sodium-ion transfer based on the week Lewis acidity of sodium-ion. In addition, the activation energies of interfacial sodium-ion transfer in dilute FEC-based electrolytes were smaller than those in concentrated electrolytes. The activation energies of the interfacial lithium/sodium-ion transfer of CNS-1100 in FEC-based electrolyte solutions were almost the same as those of CNS-2900, indicating that the mechanism of interfacial charge-transfer reaction seemed to be the same for highly graphitized materials and low-graphitized materials each other. Graphic abstract