Wurtzite ferroelectrics are an emerging material class that expands the functionality and application space of wide bandgap semiconductors. Promising physical properties of binary wurtzite semiconductors include a large, reorientable spontaneous polarization, direct band gaps that span from the infrared to ultraviolet, large thermal conductivities and acoustic wave velocities, high mobility electron and hole channels, and low optical losses. The ability to reverse the polarization in ternary wurtzite semiconductors at room temperature enables memory and analog type functionality and quasi-phase matching in optical devices and boosts the ecosystem of wurtzite semiconductors, provided the appropriate combination of properties can be achieved for any given application. In this article, advances in the design, synthesis, and characterization of wurtzite ferroelectric materials and devices are discussed. Highlights include: the direct and quantitative observation of polarization reversal of ∼135 μC/cm2 charge in Al1−xBxN via electron microscopy, Al1−xBxN ferroelectric domain patterns poled down to 400 nm in width via scanning probe microscopy, and full polarization retention after over 1000 h of 200 °C baking and a 2× enhancement relative to ZnO in the nonlinear optical response of Zn1−xMgxO. The main tradeoffs, challenges, and opportunities in thin film deposition, heterostructure design and characterization, and device fabrication are overviewed.
Zn0.64Mg0.36O (ZMO) is a newly discovered ferroelectric oxide with the wurtzite structure. Epitaxial Zn0.64Mg0.36O films from 0.036 to 0.5 μm in thickness are grown on Pt/sapphire with the crystallographic c-axis out of plane. At room temperature, the remanent polarization is ∼80 μC/cm2 and the coercive field is ∼3 MV/cm. The coercive field is strongly temperature dependent up to 240 °C with a pseudo-activation energy of 23 ± 0.3 meV, suggesting that polarization reversal occurs through an extrinsic process such as domain wall motion. ZMO films can be woken up in 20 electric field cycles on driving near the coercive field; they wake up in a single loop at fields in excess of 4 MV/cm. A thermally activated fluid imprint process, with a pseudo-activation energy of 67 ± 8 meV, enlarges the coercive field by several hundred kV cm−1 after switching the polarization. Additionally, ZMO films exhibit excellent retention characteristics; no reduction in the polarization is observed up to 1000 h from room temperature to 200 °C bakes. This current early generation of ZMO films can survive several thousand switching cycles before dielectric breakdown occurs.
Ferroelectrics are of practical interest for non‐volatile data storage due to their reorientable, crystallographically defined polarization. Yet efforts to integrate conventional ferroelectrics into ultrathin memories have been frustrated by film‐thickness limitations, which impede polarization reversal under low applied voltage. Wurtzite materials, including magnesium‐substituted zinc oxide (Zn,Mg)O, have been shown to exhibit scalable ferroelectricity as thin films. In this work, the origins of ferroelectricity in (Zn,Mg)O are explained, showing that large strain fluctuations emerge locally in (Zn,Mg)O and can reduce local barriers to ferroelectric switching by more than 40%. Concurrent experimental and computational evidence of these effects are provided by demonstrating polarization switching in ZnO/(Zn,Mg)O/ZnO heterostructures featuring built‐in interfacial strain gradients. These results open up an avenue to develop scalable ferroelectrics by controlling strain fluctuations atomistically.
This study reports the thickness scaling of sputtered ferroelectric Zn0.61Mg0.39O (ZMO) thin films down to 43 nm. Encapsulated IrO2/ZMO/Ir capacitors exhibited switchable polarizations exceeding 50 μC cm−2 and coercive fields that increased from 3.9 to 4.4 MV cm−1 as the thickness decreased. Switching kinetics are best described by the simultaneous non-linear nucleation and the growth model. Bimodal switching is prevalent at low thicknesses, with the fastest switching times measured to be approximately 400 ns. Device encapsulation made ZMO switching kinetics more abrupt, potentially due to changes in the concentration of atmosphere-induced defects such as hydroxides. These results demonstrate stable ferroelectricity and sub-microsecond switching in sub-50 nm wurtzite ZMO, highlighting its potential as a low-voltage ferroelectric for integrated nonvolatile memory applications.