Hector Pettenghi

Hector Pettenghi

Auto-generated profile, based on publicly available information

Hector Pettenghi

Department of Electrical and Electronic Engineering Federal University of Santa Catarina (UFSC) Florianópolis Santa Catarina Brazil

Research Focus & Metrics

Academic Career Length

24Years (2003-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
16 October 2003 in Electronics Letters
Verified
Journal Article
Closed access
MAM.J. Avedillo
M.J. Avedillo
JQJ.M. Quintana
J.M. Quintana
HPH. Pettenghi
H. Pettenghi
PKP.M. Kelly
P.M. Kelly
CTC.J. Thompson
C.J. Thompson

1 February 2008 in Microelectronics Journal
Verified
Journal Article
Closed access
HPHector Pettenghi
Hector Pettenghi
MAMaría J. Avedillo
María J. Avedillo
JQJosé M. Quintana
José M. Quintana

4 November 2013 in IEEE Transactions on Circuits and Systems II: Express Briefs
Verified
Journal Article
Closed access
HPHector Pettenghi
Hector Pettenghi
Ricardo ChavesRicardo Chaves
Ricardo Chaves
LSLeonel Sousa
Leonel Sousa
In recent years, research on residue number systems (RNS) has targeted larger dynamic ranges (DRs) in order to further explore their inherent parallelism. In this brief, we start from the traditional three-moduli set {2n, 2n - 1, 2n + 1}, with an equivalent 3 n-bit DR; propose horizontal and vertical extensions to scale the DR; and improve the parallelism according to the requirements. This brief also introduces a method to design general reverse converters for extended moduli sets with the desired DRs, whereas the existing state of the art allows to achieve at most (8n + 1) bit. The experimental results suggest that the proposed moduli set extensions allow for larger and more balanced moduli sets, in comparison with the state of the art, resulting in an improvement of the overall RNS performance at the cost of a slower reverse conversion operation.

15 May 2006 in IEEE Transactions on Circuits and Systems II: Analog and Digital Signal Processing
Verified
Journal Article
Closed access
MAM.J. Avedillo
M.J. Avedillo
JQJ.M. Quintana
J.M. Quintana
HPH. Pettenghi
H. Pettenghi
One of the most attractive features of MOBILE-based circuits is their self-latching operation, which allows pipelining at the gate level, and thus very high through-output, without any area overhead associated to the addition of the latches. However, the self-latching behavior is not inherent to the practical circuit topologies employed to implement MOBILE circuits. This paper reports on very simple MOBILE structures supporting this statement. The analysis performed is useful in extracting design guidelines to guarantee the required behavior.

6 February 2023 in Electronics
Verified
Journal Article
Open access
PDF file
FFFrederico Ferlini
Frederico Ferlini
FVFelipe Viel
Felipe Viel
Laio Oriel SemanLaio Oriel Seman
Laio Oriel Seman
HPHector Pettenghi
Hector Pettenghi
Eduardo BezerraEduardo Bezerra
Eduardo Bezerra
Valderi Reis Quietinho LeithardtValderi Reis Quietinho Leithardt
Valderi Reis Quietinho Leithardt
The increasing complexity of System-on-Chip (SoC) and the ongoing technology miniaturization on Integrated Circuit (IC) manufacturing processes makes modern SoCs more susceptible to Single-Event Effects (SEE) caused by radiation, even at sea level. To provide realistic estimates at a low cost, efficient analysis techniques capable of replicating SEEs are required. Among these methods, fault injection through emulation using Field-Programmable Gate Array (FPGA) enables campaigns to be run on a Circuit Under Test (CUT). This paper investigates the use of an FPGA architecture to speed up the execution of fault campaigns. As a result, a new methodology for mapping the CUT occupation on the FPGA is proposed, significantly reducing the total number of faults to be injected. In addition, a fault injection technique/flow is proposed to demonstrate the benefits of cutting-edge approaches. The presented technique emulates Single-Event Transient (SET) in all combinatorial elements of the CUT using the Internal Configuration Access Port (ICAP) of Xilinx FPGAs.

3 November 2009 in IEEE Transactions on Nanotechnology
Verified
Journal Article
Closed access
HPHéctor Pettenghi
Héctor Pettenghi
MAMaría J. Avedillo
María J. Avedillo
JQJosé M. Quintana
José M. Quintana
Many logic circuit applications of resonant tunneling diodes are based on the monostable-bistable logic element (MOBILE). Threshold logic is a computational model widely used in the design of MOBILE circuits, i.e., these circuits are built from threshold gates (TGs). This paper describes the design of full adders (FAs), using TG-based circuit topologies. Both the selection of different MOBILE TG networks and the use of gates that can be considered extensions of the MOBILE TG are addressed. The FAs are applied to the design of nanopipelined carry propagations adders, which are evaluated and compared to a previously reported one, showing advantages in terms of speed, power, and power-delay product.