A 1.6 μm differential absorption Lidar (DIAL) system for measurement of vertical CO2 mixing ratio profiles has been developed. A comparison of CO2 vertical profiles measured by the DIAL system and an aircraft in situ sensor in January 2014 over the National Institute for Environmental Studies (NIES) in Tsukuba, Japan, is presented. The DIAL measurement was obtained at an altitude range of between 1.56 and 3.60 km with a vertical resolution of 236 m (below 3 km) and 590 m (above 3 km) at an average error of 1.93 ppm. An in situ sensor for cavity ring-down spectroscopy of CO2 was installed in an aircraft. CO2 mixing ratio measured by DIAL and the aircraft sensor ranged from 398.73 to 401.36 ppm and from 399.08 to 401.83 ppm, respectively, with an average difference of −0.94 ± 1.91 ppm below 3 km and −0.70 ± 1.98 ppm above 3 km between the two measurements.
The accurate vertical CO2 profiles in the troposphere are highly desirable in the inverse techniques to improve quantification and understanding of the global budget of CO2 and also global climate changes. Moreover, wind information is an important parameter for transport simulations and inverse estimation of surface CO2 flux. A differential absorption lidar (DIAL) is an attractive method for obtaining vertical CO2 profiles and we have developed an 1.6μm DIAL system to perform simultaneous measurements of CO2 concentration, atmospheric temperature profile and wind profile. The absorption cross sections of gas and air density depends on atmospheric temperature and pressure. Then precise temperature and pressure profiles are necessary for accurate CO2 mixing ratio measurement by DIAL. Laser beams of three wavelengths around a CO2 absorption line are transmitted alternately to the atmosphere for simultaneous measurements of CO2 concentration and temperature. The receiving optics include the near-infrared photomultiplier tube and a fiber Bragg grating (FBG) filter to detect a Doppler shift.
In recent years, the frequency of occurrence of locally heavy rainfall that can cause extensive damages, has been increasing in Japan. For early prediction of heavy rainfall, it is useful to measure the water vapor vertical distribution upwind cumulus convection beforehand. For that purpose, we have been developing compact water vapor differential absorption lidar (DIAL).We show the results of the measurements with lidar in summer when the local heavy rainfall frequently occurs in Japan. We also show the preliminary result of the assimilation of the lidar data to the numerical model and impact on the heavy rainfall prediction.
We present a new method of the rotational Raman lidar using an absorption cell of metallic vapor. The conventional rotational Raman lidar can hardly measure the temperature profiles in the atmosphere containing a lot of aerosol particles like in the lower troposphere. In this paper, it is shown by the computer simulation that the aerosol scattering contamination disturbing the measurement can be easily eliminated by using a metallic vapor filter in addition to the interference filters. Moreover, the interference filters of which the characteristics affect decisively the measurement accuracy can be designed more suitably. We design and fabricate the lidar system with a Na vapor cell and a narrowband dye laser to prove the usefulness of this method experimentally.
We investigated the relation between major tropical volcanic eruptions in the equatorial region and the stratospheric aerosol data, which have been collected by the ground based lidar observations at at Equatorial Atmosphere Radar site between 2004 and 2015 and the CALIOP observations in low latitude between 2006 and 2015. We found characteristic dynamic behavior of volcanic stratospheric aerosol layers over equatorial region.