Bate Bate

Bate Bate

Auto-generated profile, based on publicly available information

Bate Bate

Department of Civil, Architectural and Environmental Engineering, Missouri University of Science and Technology, Rolla, MO 65409, USA

Research Focus & Metrics

Academic Career Length

14Years (2013-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
25 February 2016 in Sustainability
Verified
Journal Article
Open access
PDF file
SCShuang Cindy Cao
Shuang Cindy Cao
BBBate Bate
Bate Bate
Jong Wan HuJong Wan Hu
Jong Wan Hu
JJJongwon Jung
Jongwon Jung
Biopolymers have shown a great effect in enhanced oil recovery because of the improvement of water-flood performance by mobility control, as well as having been considered for oil contaminated-soil remediation thanks to their mobility control and water-flood performance. This study focused on the wettability analysis of biopolymers such as chitosan (85% deacetylated power), PEO (polyethylene oxide), Xanthan (xanthan gum), SA (Alginic Acid Sodium Salt), and PAA (polyacrylic acid), including the measurements of contact angles, interfacial tension, and viscosity. Furthermore, a micromodel study was conducted to explore pore-scale displacement phenomena during biopolymer injection into the pores. The contact angles of biopolymer solutions are higher on silica surfaces submerged in decane than at atmospheric conditions. While interfacial tensions of the biopolymer solutions have a relatively small range of 25 to 39 mN/m, the viscosities of biopolymer solutions have a wide range, 0.002 to 0.4 Pa·s, that dramatically affect both the capillary number and viscosity number. Both contact angles and interfacial tension have effects on the capillary entry pressure that increases along with an applied effective stress by overburden pressure in sediments. Additionally, a high injection rate of biopolymer solutions into the pores illustrates a high level of displacement ratio. Thus, oil-contaminated soil remediation and enhanced oil recovery should be operated in cost-efficient ways considering the injection rates and capillary entry pressure.

24 February 2014
Verified
Conference Paper
Closed access
Xin KangXin Kang
Xin Kang
BBBate Bate
Bate Bate
LGLouis Ge
Louis Ge
Small strain stiffness of granular materials is important to many engineering applications, such as earthquake engineering, pavement, machine foundation, embankment subjected to tidal impacts, and foundations for structures under wind loads. Shear wave velocity, which is an indicator of stiffness, was measured with a newly developed bender element testing system. Test data supported that this testing system is effective in evaluating the shear wave velocity and its anisotropy of uniform spherical granular materials, including glass beads, uniform medium, and fine sands. Influencing factors on the Vs such as grain size and applied stress were studied. Two components of the soil stiffness anisotropy, namely stress anisotropy and fabric anisotropy were discussed. It was found that Vs anisotropy emerged for fine-grained soils at high consolidation stresses, indicating that the contact normal, or the magnitude and direction of interparticle contacts, between particles could be anisotropic. Vs anisotropy is not obvious for 6mm glass bead samples. An empirical equation relating α and β coefficient of equation Vs = α(σ'm/1kPa)β was proposed based on test results in this study: β = 1,217.93/(α+117.21)1.64. It was also observed that given equal other conditions, large particles, which possess significantly fewer contacts than small particles do, seem to transmit shear waves faster. However, the similar Vs values of granular samples with intermediate d50 sizes (0.26 - 3 mm) indicated that other mechanism(s) would contribute to the recorded Vs values.