1 January 2021 in Materials Research
CRCassius Olívio Figueiredo Terra Ruchert
Cassius Olívio Figueiredo Terra Ruchert
MMMarcos Fábio Verísimo Montezuma
Marcos Fábio Verísimo Montezuma
30 May 2024 in Journal of the Brazilian Society of Mechanical Sciences and Engineering
CRCassius Olívio Figueiredo Terra Ruchert
Cassius Olívio Figueiredo Terra Ruchert
1 January 2024 in Anais da Academia Brasileira de Ciências
This study addresses the prediction of fatigue life in SAE AMS 7475-T7351 aluminum alloys under variable loads, commonly used in the construction of aircraft fuselages. The main objective of the research was to develop a numerical-experimental procedure to analyze crack growth, using the Walker’s approach which considers the effects of the stress ratio on the fatigue crack growth rate , combined with the Finite Element Method and Linear Regression of the Stress Intensity Factor. Observations showed that Walker’s model effectively consolidated fatigue crack propagation data for various stress ratios when applied longitudinally to L-T rolling orientation, due to low dependence of exponent on -value in equation. Simple averaging of values effectively calculated Walker’s exponent. The methodology employed experimental tests following ASTM standards for tension, fracture toughness, and fatigue, complemented by Finite Element Method (FEM) simulations. The Walker’s model proved more effective, while the Paris-Erdogan model, which ignores the effect, resulted in overly conservative service life estimates. The principle of similitude suggests that this methodology could be effective in predicting fatigue life in cases with complex geometries, where calculating the Stress Intensity Factor Fracture parameter is challenging and the Finite Element Method shows efficiency.
1 January 2026 in Materials Research
Accurate fatigue-life prediction under variable-amplitude loading (VAL) is critical for damage-tolerance assessment. This study presents a systematic comparative analysis of experimental data and numerical predictions of crack propagation in SAE-AMS 7475-T7351 alloy. NASGRO, AFGROW, and CRACK 2000 were employed to simulate standardized spectra (TWIST, FALSTAFF) and an actual commercial aeronautical load history, focusing on the calibration of Wheeler, GW, and MGW retardation models. The results demonstrate that calibration parameters (e.g., Rso) are highly spectrum-dependent. Physical analysis revealed that underloads attenuate retardation in the TWIST spectrum but are ineffective in the FALSTAFF spectrum. Discrepancies between the software packages, even with identical parameters, were attributed to varying ΔKth implementations.
13 November 2023 in Research Square
CRCassius Olívio Figueiredo Terra Ruchert
Cassius Olívio Figueiredo Terra Ruchert
This work investigated the possible causes of premature failure of a steam turbine blade made from X20CrMo13 stainless steel. During their operation in power generation plants, the blades may suffer service failures that occur naturally or accelerated due to metallurgical or mechanical causes. In this work, one investigated the possible causes of the failure of a martensitic stainless steel turbine blade operating in a 25 MW turbine in a quenched and tempered cogeneration plant that fractured during operation. The results showed a martensitic structure with a delta ferrite content above 5%. Beach marks and fatigue striations were observed, arising from fatigue crack propagation. The tensile test showed an area reduction of 15%, probably due to carbide precipitation. Keywords: Turbine blade; Stainless steel; Fatigue; Failure Analysis.