18 August 2021 in IEEE Transactions on Power Electronics
Wireless power transfer (WPT) is emerging as the preeminent way to charge electric vehicles, but there appears to be no fair way to measure the power transfer. In this article, Faraday coil transfer-power measurement (FC-TPM) is presented. FC-TPM employs non-contact, open-circuited sense coils to measure the electromagnetic field from WPT and calculates the real power propagating through the air gap between the transmitter and receiver coils. What is measured is the real electromagnetic power, representing the pure dispensation of energy that unambiguously demarcates the losses on either side. FC-TPM was demonstrated to be 0.1% accurate in hardware over an Rx coil misalignment of up to 10 cm using a 1-kW WPT system. Fair metering incentivizes businesses and individuals to make choices that conserve energy and advance technology by providing more information and by properly assigning the financial loss. This article is accompanied by a video highlighting the essential contributions of this article.
27 July 2021 in IEEE Transactions on Power Electronics
Foreign objects near wireless power transfer (WPT) systems are fire hazards that must be detected. In this article, a new accurate method is presented for foreign object detection based on an electromagnetic model for WPT. Foreign objects are detected by quantifying the deviation from a normal model. This deviation is caused by the foreign object's additional electromagnetic coupling. Advantages of this new method include invariance to receiver coil misalignment, and power level, allowing low-power detection prior to startup. Electromagnetic model-based foreign object detection was demonstrated in hardware to detect a 2 cm diameter U.S. nickel coin, a small disposable lighter, and a saline proxy for a living animal in a kilowatt-level wireless power transfer system, using a prestartup power of only 7 W. Furthermore, foreign objects can be detected regardless of an Rx coil misalignment of up to 10 cm. This article is accompanied by an instructional video.
30 December 2010 in IEEE Transactions on Applied Superconductivity
This study deals with a conceptual design for a high temperature superconductor (HTS) coil fabricated with YBCO wire in a prototype HTS-electromagnet (HTS-EM) model for the electromagnetic suspension (EMS)-based Maglev. Because the size of the HTS coil and the power it consumes during operation are very critical factors in designing the HTS-EM, we focused on the number of coil turns and the operating conditions needed to generate the required magneto-motive force (MMF) effectively. The winding geometry of the sample HTS coil with the largest Ic value was selected for use in this study. To determine the operating condition corresponding to the number of coil turns, we produced the operating profile for the load current of DC current source and the Ic value of HTS coil. From the profile, the optimal number of coil turns to minimize the operating power is determined to be in the range of 1200 to 1400 turns. And the HTS coil should be operated with the current of 37 to 43 A at the cooling temperature of 73 to 76 K.
28 January 2011 in IEEE Transactions on Applied Superconductivity
In order to limit fault current from an accident in power grid, many research groups have developed resistive superconducting fault current limiters (SFCLs) with a bifilar solenoid and a bifilar pancake types. Comparing with a bifilar solenoid type, a bifilar pancake type has the advantage of its volume, but it has problems such as recovery and insulation of SFCLs. To eliminate the drawback of these two types, in this paper, a new type of coil that is an oval-shaped SFCL, have proposed. This type consists of inner and outer layers which are connected in parallel. A small-scale sample coil was fabricated and experiments for both a short circuit test and recovery characteristic test were performed in liquid nitrogen. Experimental results were compared with two types of coils; the bifilar solenoid and bifilar pancake coil. Consequently, we confirmed the feasibility of an oval-shaped type.
1 November 2011 in Physica C: Superconductivity and its Applications