10 April 2023 in Matter and Radiation at Extremes
Ultra-intense laser-driven fast electron beam propagation in a silicon target is studied by three-dimensional hybrid particle-in-cell–fluid simulations. It is found that the transverse spatial profile of the fast electron beam has a significant influence on the propagation of the fast electrons. In the case of a steep spatial profile (e.g., a super-Gaussian profile), a tight fast electron beam is produced, and this excites more intense resistive magnetic fields, which pinch the electron beam strongly, leading to strong filamentation of the beam. By contrast, as the gradient of the spatial profile becomes more gentle (e.g., in the case of a Lorentzian profile), the resistive magnetic field and filamentation become weaker. This indicates that fast electron propagation in a solid target can be controlled by modulating the spatial gradient of the laser pulse edge.
1 June 2023 in Physics of Plasmas
The non-local heat transport of hot electrons during high-intensity laser interaction with plasmas can preheat the fuel and limit the heat flow in inertial confinement fusion. It increases the entropy of the fuel and decreases the final compression. In this paper, the non-local electron transport model that is based on the improved Schurtz–Nicolaï–Busquet (SNB) algorithm has been embedded into the radiation hydrodynamic code and is benchmarked with two classical non-local transport cases. Then, we studied a 2ω laser ablating a CH target by using the non-local module. It is found that the non-local effect becomes significant when the laser intensity is above 1×1014W/cm2. The mass ablation rate from the SNB model is increased compared to that of the flux-limited model due to the lower coronal plasma temperature. This non-local model has a better agreement with the experimental results compared to that of the flux-limited model. The non-local transport is strongly dependent on the laser frequency, and the thresholds that the non-local transport should be considered are obtained for lasers of different frequencies. The appropriate flux-limiters that should be employed in the flux-limited model for different lasers are also presented. The results here should have a good reference for the laser-target ablation applications.
8 October 2024 in Nuclear Fusion
Ablative Rayleigh–Taylor instability (ARTI) and nonlocal heat transport are the critical problems in laser-driven inertial confinement fusion, while their coupling with each other is not completely understood yet. Here the ARTI in the presence of nonlocal heat transport is studied self-consistently for the first time theoretically and by using radiation hydrodynamic simulations. It is found that the nonlocal heat flux generated by the hot electron transport tends to attenuate the growth of instability, especially for short wavelength perturbations. A linear theory of the ARTI coupled with the nonlocal heat flux is developed, and a prominent stabilization of the ablation front via the nonlocal heat flux is found, in good agreement with numerical simulations. This effect becomes more significant as the laser intensity increases. Our results should have important references for the target designing for inertial confinement fusion.
23 July 2024 in Plasma Physics and Controlled Fusion
High-Z dopants such as chlorine, bromine and silicon in carbon–hydrogen polymer (CH) targets play a crucial role during the ablation of inertial confinement fusion (ICF). These dopants can serve as diagnostic tools in experiments and mitigate hot electron preheating, but they also influence the laser ablation. In this paper, the process of high-power laser ablating doped CH targets has been studied through radiation hydrodynamic simulations. Our findings reveal that the laser absorption rate in the doped targets increase as a result of the increasing electron-ion collision frequency. This leads to the increase of the electron, ion and radiation temperatures. Furthermore, high-Z dopants contribute to a decrease in the ablation pressure, which tends to a constant. Moreover, the saturation phenomenon of the mass ablation rate has been found. For the targets with low doping ratios (e.g. 6.25%–12.5%), the mass ablation rate increases until reaching the saturation at a doping ratio of 18.75%, after which it decreases. This indicates that an appropriate doping ratio can increase the laser absorption and ablation. The results are helpful to comprehensively understand the effects of high-Z dopant on all stages of ICF.
23 May 2025 in Nuclear Fusion
The control of Rayleigh–Taylor instability (RTI) in target implosion compression is a classical problem in laser-driven inertial confinement fusion (ICF). Modeling the evolution of RTI by using high-dimensional radiation hydrodynamics simulations requires significant computational resources. In this paper, we present a novel approach to evaluate and predict the growth of RTI in direct-driven ICF. The target implosion velocities and accelerations at critical moments are derived according to the laser profiles and the target structures by the hydro-equivalent analysis and spherical ablation theory, combined with the adiabat from the one-dimensional simulation. Then, combining with the nonlinear RTI theory, the RT spikes penetration ratio is used to evaluate the integrity of the target. The most stable laser profile and target structure design can be quickly selected and the development of RTI is verified in the two-dimensional radiation hydrodynamics simulation. The results show that the areal density is increased by 68.2% by applying the most stable laser profile and target structure design compared with that of the initial case. These findings have significant implications for enhancing direct-drive ICF instability control.
7 October 2025 in Matter and Radiation at Extremes
In the direct drive inertial confinement fusion (ICF) scheme, a rippled interface between the ablator and the deuterium–tritium ice fuel can feed out and form perturbation seeds for the ablative Rayleigh–Taylor instability, with undesirable effects. However, the evolution of this instability remains insufficiently studied, and the effects of high-Z dopant on this instability remain unclear. In this paper, we develop a theoretical model to calculate the feedout seeds and describe this instability. Our theory suggests that the feedout seeds are determined by the ablation pressure and the adiabatic index, while the subsequent growth depends mainly on the ablation velocity. Two-dimensional radiation hydrodynamic simulations confirm our theory. It is shown that targets with high-Z dopant in the outer ablator exhibit more severe feedout seeds, because of their higher ionization compared with undoped targets. The X-ray pre-ablation in high-Z doped targets significantly suppresses subsequent growth, leading to suppression of short-wavelength perturbations. However, for long-wavelength perturbations, this suppression is weakened, resulting in increased instability in high-Z doped targets. The results are helpful for understanding the inner-interface-initiated instability and the influence of high-Z dopant on it, providing valuable insights for target design and instability control in ICF.