Romero César Gomes

Romero César Gomes

Auto-generated profile, based on publicly available information

Romero César Gomes

Universidade Federal de Ouro Preto

Research Focus & Metrics

Academic Career Length

19Years (2008-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 October 2008 in Geosynthetics International
Verified
Journal Article
Closed access
GFG. Fernandes
G. Fernandes
EPEnnio Marques Palmeira
Ennio Marques Palmeira
RGR. C. Gomes
R. C. Gomes
Geosynthetics have been used as reinforcement in various applications in geotechnical engineering. This paper presents a study on the use of geosynthetic reinforcement to reduce the consumption of good-quality sub-ballast material in a railway track in the state of Minas Gerais, Brazil. Six test sections on the railway were instrumented and monitored for a period of 2 years. Nonwoven geotextile and a geogrid were used as reinforcement in different positions in the sub-ballast. The results obtained showed that the presence of geosynthetic reinforcement reduced the strains mobilised in the sub-ballast, reduced the breakage of ballast element, and allowed the use of a cheaper alternative material in the sub-ballast construction. The results showed the potential of the use of alternative sub-ballast material reinforced with geosynthetic to reduce the costs of construction and maintenance of railway tracks.

23 March 2023 in Buildings
Verified
Journal Article
Open access
PDF file
SFSâmara França
Sâmara França
LSLeila Nobrega Sousa
Leila Nobrega Sousa
SSSérgio Luiz Costa Saraiva
Sérgio Luiz Costa Saraiva
MFMaria Cecília Novaes Firmo Ferreira
Maria Cecília Novaes Firmo Ferreira
MSMarcos Vinicio de Moura Solar Silva
Marcos Vinicio de Moura Solar Silva
Augusto Cesar da Silva BezerraAugusto Cesar da Silva Bezerra
Augusto Cesar da Silva Bezerra
This work presents a technical and economic study using sugar cane bagasse ash (SCBA) to partially replace Portland cement clinker. To evaluate the technical viability, the replacement rates of 10, 20, and 30% of Portland cement were used in the experiments. The ashes used were in the following conditions: (i) as collected (AC), (ii) ground (G), and (iii) re-burnt and ground (RG). Three composition parameters were used in the mortar mix procedures: (i) mix with water factor/fixed binder in volume, (ii) mix with water factor/fixed binder in weight, and (iii) mix with the fixed flow. After the technical feasibility analysis, the benefit of the substitutions and an analysis of the relationship between cement consumption and the acquired compressive strength, correlating with possible economic costs, were discussed. SCBA AC was not suitable for the partial replacement of Portland cement clinker. SCBA G presented a satisfactory performance and SCBA RG was the ash that presented the best performance in the partial replacement of Portland cement clinker. For the same levels of compressive strength, the consumption of Portland cement per cubic meter of concrete reduced; from this, the cost of concrete and mortar could be reduced by 8%, with the ash having the same value as cement. Furthermore, the use of SCBA RG at 30% inhibited the alkali–silica reaction (ASR) in concretes with a reactive basalt and quartzite aggregate. SCBA G (20 and 30%) and SCBA RG (10 and 20%) inhibited the ASR in concretes with a reactive basalt aggregate and reduced the expandability in concretes with a reactive quartzite aggregate. Another point to highlight was the durability shown by the cements with SCBA, which, 900 days after the accelerated test of expansion by the alkali–aggregate reaction, maintained high levels of flexural strength when compared to the results obtained before the accelerated test of expansion. The present work concluded that using sugar cane bagasse ash to replace Portland cement is feasible from a technical, environmental, and economic perspective.

1 January 2013 in Soils and Rocks
Verified
Journal Article
Closed access
PDF file
WPWashington Pirete
Washington Pirete
RGRomero C. Gomes
Romero C. Gomes
Tailings dams constructed using the upstream method generally have relatively low- density materials with a high degree of saturation. Such conditions can generate the phenomena of liquefaction, which is potentially critical in slurry tailings disposal systems. Slope stability analyses involving liquefied soil require that the shear resistance of the softened soil be estimated and then, a good practical alternative is back-analyzed with field case studies involving slope failures, using commonly SPT and CPT results. The Olson (2001) and Olson & Stark (2003b) liquefaction analysis methodology based on strength ratios, included in this approach, is comprised of three stages: (i) liquefaction susceptibility analysis; (ii) triggering analysis; and (iii) post-triggering - flow failure stability analysis. In this paper, this approach was applied for stability assessments to verify liquefaction potential in an upstream tailings dam built by the hydraulic fill technique and located in the Quadrilátero Ferrífero (Iron Quadrangle) region, southeastern of Brazil. The results ratified the safety condition of the impoundment although they have demonstrated that the tailings tend to exhibit contractile behavior during shear, indicating liquefaction susceptibility.

10 July 2020 in Bulletin of Engineering Geology and the Environment
Verified
Journal Article
Closed access
PDF file
BCBruno de Oliveira Costa Couto
Bruno de Oliveira Costa Couto
RGRomero César Gomes
Romero César Gomes
LFLucas Deleon Ferreira
Lucas Deleon Ferreira

1 December 2020 in REM - International Engineering Journal
Verified
Journal Article
Open access
PDF file
APArmando Belato Pereira
Armando Belato Pereira
TPThiago Bomjardim Porto
Thiago Bomjardim Porto
RGRomero César Gomes
Romero César Gomes
Raphael Lúcio Reis dos SantosRaphael Lúcio Reis dos Santos
Raphael Lúcio Reis dos Santos
JRJoão Marcos Guimarães Rabelo
João Marcos Guimarães Rabelo
This article presents a study on the performance of semi-empirical methods based on the Standard Penetration Test (SPT) for the prediction of bearing capacity already disseminated in the practice of Brazilian Foundation Engineering (Aoki and Velloso, 1975; Décourt and Quaresma, 1978, 1996; Teixeira,1996), together with the recent method proposed by Pereira (2020), and the theoretical method known as a Method (disseminated around the world). These were applied to precast concrete piles based on sandy clay in the Uberlândia-MG region. In the performance analysis, the ultimate shaft and tip resistances and the bearing capacity values, which were utilized as references, were mobilized in the dynamic loading tests performed on ten piles. The results of these tests were compared with those obtained using the mentioned methods. In general, both methods yielded robust results, with relatively accurate predictions, except the a Method, which was found to perform below the semi-empirical methods considered. The research still highlights the need for discretion in the application of semi-empirical/theoretical methodologies because there are certain scenarios wherein these methods can yield inaccurate results.

1 December 2020 in REM - International Engineering Journal
Verified
Journal Article
Open access
PDF file
GSGustavo Marçal Sousa
Gustavo Marçal Sousa
RGRomero César Gomes
Romero César Gomes
This article introduces a hassle-free methodology for geotechnical parameters to be obtained from correlations between geophysics and CPT field tests in tailings dams undergoing the decommissioning process, which are reasonably representative of site conditions, from the very early project stages, with extensive coverage of all impoundment parts, without the requirement for large-size drilling programs. The development methodology consists of running direct (CPT) and indirect (geophysics) tests within the same area of the tailings dam to be decommissioned, with information crosschecking, thus allowing for results to be presented as adjustment equations, capable of describing tailings undrained shear strength based on geophysical survey data. A dam within the region known as Iron Quadrangle, in the state of Minas Gerais, Brazil, was selected to pilot the tests. The results obtained showed consistent adjustments, thus validating the proposed methodology as a complementary geotechnical investigation tool, and also enabling an optimized investigation plan to be proposed for similar tailings dams undergoing a mining process, so as to provide better assessment of the safety conditions of the proposals for deactivation with reduced schedule and resource savings.