This manuscript investigates the supercritical carbon dioxide (sCO) power cycle employed in the power block of concentrated solar power (CSP) plants—solar tower—as an alternative for solar desalination, developed with either distillation or reverse osmosis. This concept is investigated as a possible up-scaling of the SOLMIDEFF project, originally based on a hot-air micro gas turbine combined with a solar dish collector. For the upscaled concept, five different sCO cycles are considered, chosen amongst the best-performing configurations proposed in the literature for CSP applications, and modelled with Thermoflex software. The influence of ambient conditions is studied, considering two minimum cycle temperatures (35 °C and 50 °C), corresponding to Santa Cruz de Tenerife and Abu Dhabi, respectively. The results show that the low temperatures at the inlet of the heat rejection unit compromise the viability of distillation technologies. On the other hand, the high thermal efficiency achieved by these cycles, especially with the recompression and partial cooling layouts, reduces the specific energy consumption when combined with reverse osmosis (RO), below that of photovoltaic (PV)+RO. Feed-water preheating is explored as a solution to further reduce energy consumption, concluding that its actual interest is not clear and strongly depends on the location considered and the corresponding water quality standards.
1 December 2001 in SAE International Journal of Advances and Current Practices in Mobility
Before an engine leaves the manufacturing and/or assembly plant it must undergo different tests in order to control the quality of the engine. These tests are time consuming and also need a specialist worker who can identify anomalies in the engine, mainly through a very well trained “ear”. This paper shows the development and the application of a methodology which can be able to diminish the running-in period and to identify malfunctions related to the combustion process in a plant for the manufacturing of direct injection diesel engine. The method is based on the formulation of two submodels included in a model of the dynamic of the engine, where the crankshaft is assumed as rigid body. One of the submodels relates the instantaneous mechanical losses of the engine with design and operating parameters. The other submodel defines the burning rate through a Wiebe function which depends of six parameters that change with operating conditions. The method has been applied to three different engines models (one, two and four cylinders), and the results are encouraging.