10 May 2024 in Journal of Infrared, Millimeter, and Terahertz Waves
This study presents a planar dual-band multiple-input multiple-output (MIMO) antenna design for the prospective fifth-generation (5G) frequency bands of 28 and 38 GHz. The antenna element is designed by utilizing a rectangular patch with an offset microstrip feeding technique. A dual-band response is achieved by placing semi-circular slots on each side of the patch element. To tune the frequency response and improve impedance matching, vertical rectangular slits are etched in the rectangular patch and the ground plane, respectively. The results show that the single antenna element offers an impedance bandwidth of 2.52 GHz (26.32–28.84 GHz) and 7.5 GHz (34–41.5 GHz). In addition, a MIMO configuration based on pattern diversity using four antenna elements is designed and fabricated. The designed MIMO configuration achieves an impedance bandwidth of 3 GHz (27–30 GHz) and 5.46 GHz (35.54–41 GHz) at operating bands of 28 and 38 GHz. The peak realized gain for the single element at 28 and 38 GHz is noted to be 7.4 dBi and 7.5 dBi, respectively. Furthermore, the polarization diversity configuration illustrates an isolation of > 15 dB and > 25 dB for the 28 and 38 GHz frequency bands, respectively. Moreover, the MIMO configuration attains appropriate values for the envelope correlation coefficient (ECC) and diversity gain (DG), Total Active Reflection Co-efficient (TARC), Channel Capacity Loss (CCL) and Mean Effective Gain (MEG) for the operating frequency bands. The proposed MIMO system based on results seems to be potential choice for mmwave Ka Band Applications.
31 July 2024 in Journal of Electromagnetic Engineering and Science
In modern communication systems, ultra-wideband (UWB) technology has garnered substantial attention due to its superior attributes compared to traditional narrowband communication systems. Over the past decade, UWB technology has also found applications in microwave-based imaging systems. This study introduces a simple planar coplanar waveguide-fed circular shape arc slot antenna designed specifically for biomedicine and microwave medical imaging applications. The proposed design is implemented on a 1.6-mm-thick FR4 substrate with a relative permittivity of 4.4 and a loss tangent of 0.0009. The antenna has physical dimensions of 26 mm × 29 mm and achieves an impressive bandwidth of 16.6 GHz, spanning 2.4 to 19 GHz. It exhibits a peak gain of 2.5 dBi and consistent omnidirectional radiation characteristics. Thorough temporal analysis validates the antenna's performance within acceptable limits, which is further affirmed through practical fabrication and testing, demonstrating strong agreement with simulation results.
1 January 2015 in Applied Mechanics and Materials
The switched mode dc-dc converters are some of the most widely used power electronics circuits because of high conversion efficiency and flexible output voltage. Many methods have been developed for the control of dc-dc converters. This paper deals with design of controller for dc-dc buck converter using various control techniques. The first two control techniques are based on classical or linear control methods i.e. PI and PID control, while the other two control technique are based on non linear control method i.e. Sliding Mode Control (SMC) and Sliding Mode Proportional Integral Derivative Control (SMC-PID). The output voltage and the inductor current of the applied control techniques are analyzed and compared in transient and steady state region. Also the robustness of the buck converter system is tested for load changes and input voltage variations. Matlab/Simulink is used for the simulations. The detailed simulation results are presented, which compare the performance of the designed controllers for various cases. The results show that the non linear control for DC/DC Buck converter proves to be more robust than linear control especially when dynamic tests are applied.