1 January 2000 in IEEE Transactions on Instrumentation and Measurement
6 June 2008 in IEEE Transactions on Instrumentation and Measurement
This paper presents a system for detection and classification of power quality (PQ) voltage disturbances. The proposed system applies the following methods to detect and classify PQ disturbances: digital filtering and mathematical morphology are used to detect and classify transients and waveform distortions, whereas for short- and long-duration disturbances (such as sags, swells, and interruptions), the analysis of the root-mean-square (RMS) value of the voltage is employed. The proposed combined approach identifies the type of disturbance and its parameters such as time localization, duration, and magnitude. The proposed system is suitable for real-time monitoring of the power system and implementation on a digital signal processor (DSP).
24 February 2009 in IEEE Transactions on Instrumentation and Measurement
A new algorithm for the estimation of the frequency of single-tone signals is presented in this paper. The algorithm works in the frequency domain and is based on best fitting a theoretical spectrum of a single-tone signal that is windowed using a rectangular window on the spectrum of the sampled signal. Using this iterative process, the algorithm compensates the spectrum leakage caused by incoherent sampling and a finite number of samples. Due to leakage compensation, the algorithm provides accurate estimates of the signal's frequency, amplitude, and phase. The influence of noise and harmonic and interharmonic distortions on the proposed algorithm was investigated and is reported here. The algorithm's performance was compared with several other frequency-estimation algorithms (mostly those working in the frequency domain). Since the algorithm is intended for power quality measurements (although it is not limited to this application), it was also tested on signals measured in a single-phase power system.
1 February 2008 in Measurement
18 May 2010 in IEEE Transactions on Instrumentation and Measurement
This paper presents a combination of two techniques for high-resolution ultrasonic distance measurements in air. The first is the cross correlation between transmitted and received signals to determine the time of flight (TOF), and the second is sine fitting of other transmitted and received signals to determine the phase shift (PS) between them. Sine fitting can estimate the PS with very high accuracy. The result of this synergy is a very accurate distance measurement. For example, the final uncertainty is less than 100 for distances up to 1200 mm.
1 January 2004 in Measurement