1 December 2020 in Physics of Fluids
An investigation into the linear instability of streamwise vortices over a yawed blunt cone with a half-angle of 7° at 6° angle of attack, a free-stream Mach number of 6, and a Reynolds number of 1.0 × 107/m was performed. The steady laminar base flow obtained using direct numerical simulation (DNS) has a mushroom structure. Three classes of unstable modes (inner mode, outer mode, and Mack mode modified by the streamwise vortices) were identified using a two-dimensional spatial global stability analysis (bi-global). Among them, the inner mode and the modified Mack mode were discovered for the first time for such a configuration. Notably, the inner mode appears only over a short distance upstream of the cone, and its energy is mainly in the vicinity of the symmetry plane of the mushroom structure. By comparing with DNS results, it was shown that multiple instability modes can coexist physically during the transition in the leeward plane. In addition, the eN method based on global stability theory was used to predict the location of the transition along the centerline on the leeward side of the cone. It was found that the inner modes grow rapidly in the upstream region, while the outer mode near the stem of the mushroom structure dominates the transition in the downstream region. Further analysis suggests that the inner modes dominate the transition only in a noisy environment, whereas the traditional centerline modes dominate the transition in quiet free-stream conditions.
1 March 2023 in AIAA Journal
Transverse rectangular microgrooves with local machining flaw are investigated using direct numerical simulations from the viewpoint of suppressing the second-mode instability in a Mach 6 hypersonic boundary layer. Two types of machining flaw are modeled for the local deformation of microgrooves, i.e., chamfered and protruded ones. The effect of locally deformed microgrooves on the boundary-layer stability is studied by superposing the second-mode disturbance to the base flow of the boundary layer. The investigated unstable second mode is 400 kHz, and the microgrooves are installed in its synchronous region. The results show that compression and expansion waves are generated on the surface of the deformed microgrooves, and microscale separation bubbles are formed at the rear edge of the deformed microgrooves. With the increase of local deformation height of microgrooves, the suppression effect of the second-mode disturbance gradually increases. As the deformation height reaches 0.09 mm, the amplitude inhibition rate of locally deformed microgrooves on the second-mode disturbance reaches 44.7%, compared to that of the regular one.
1 June 2021 in Physics of Fluids
This paper describes the design of a class of three-dimensional (3D) smooth humps mounted on a yawed cone model for a high-precision compressible Navier–Stokes solver. The influence of isolated 3D humps with different heights on the linear stability of streamwise vortices over a yawed cone with a half-angle at a angle-of-attack, free-stream Mach number of 6, and unit Reynolds number of /m is investigated. The results show that smooth humps induce stationary streaks inside the streamwise vortices over a yawed cone, effectively increasing the energy of the inward vortex and inhibiting the evolution and development of the outward vortex. Stability analysis shows that the induced streaks enhance the inner mode instability, suppress the outer mode instability, and reduce the dominant frequency of the outer mode. The stability properties of the hump-induced streaks are studied, and the physical process of the transformation between the new streak instability mode and the original boundary layer mode is revealed. The eN method based on global stability theory is used to predict the transition location along the centerline on the leeward side of the cone. It is found that configurations with hump heights of 0.153 and 0.267 times the local boundary layer thickness result in a transition delay of ∼3% and ∼11%, respectively.
20 November 2024 in Acta Mechanica Sinica
1 August 2023 in Physics of Fluids
This paper investigates the influence of three-dimensional smooth humps with varying deflection angles (φ) on the linear stability of streamwise vortices over a yawed cone with a 7° half-angle at a 6° angle-of-attack, free-stream Mach number of 6, and unit Reynolds number of 1.0×107/m. The steady laminar flow is obtained using direct numerical simulations. The eN method based on global stability theory is used to predict the transition location of the streamwise vortices along the centerline on the leeward side of the cone. The results reveal that φ plays a significant role in the outward vortex generation location, with smaller values of φ effectively delaying the outward vortex generation. Moreover, there is a qualitative relationship between the instability of the streamwise vortices and the inward/outward vortex structure characteristics of the base flow over a yawed cone. Namely, the transition delay effect of the streamwise vortices is proportional to the delay in the generation location of the outward vortex, which provides insights into the control of the transition induced by streamwise vortices. In particular, the configuration based on a hump with φ=9° and a height of 0.57 times the local boundary layer thickness delays the transition by approximately 38.2% at the critical N-factor (Ntr=12.5) without significantly increasing the instability of the inner mode.
1 January 2024 in Physics of Fluids
In this study, the influence of isolated three-dimensional (3D) humps on the linear evolution of streamwise vortex unstable modes over a yawed cone is investigated numerically. The yawed cone has a 7° half-angle at a 6° angle-of-attack, the freestream Mach number (Ma) is 6, and the unit Reynolds number is 1.0×107 m–1. The induced disturbance at the numerical inlet is obtained using the two-dimensional global stability theory (biglobal stability theory). The clear linear-evolution process and the growth rate curve of a single-frequency disturbance wave along the axial direction are obtained using well-designed direct numerical simulations. The numerical results show that the evolutionary paths of the inner and outer modes are related to the inward and outward vortices inside the mushroom structure of the leeward ray, respectively. However, a small part of the outer mode energy can also propagate downstream along the inward vortex. Moreover, the introduction of an inner mode at the inlet can not only excite the unstable inner mode but also trigger the unstable outer mode downstream after the amplitude of the inner mode is attenuated. At the same time, a clear mode transformation process among the outer modes is also observed inside the streamwise vortex-induced boundary layer. By comparing the results of the linear evolution of the disturbance over a smooth wall, it is found that the induced hump can enhance the inner mode instability, resulting in a hysteresis phenomenon of the outer mode amplification interval, which is in good agreement with the results of the spatial biglobal analysis in our previous work. Additionally, the induced hump can also delay the mode transformation process and does not induce new mode transformation mechanisms.