The optical constants of strain-balanced InAs/InAsSb and InGaAs/InAsSb superlattices and their constituents GaAs, GaSb, InAs, InSb, and InAsSb are measured using spectroscopic ellipsometry. An optical constant model is developed that accurately describes the index of refraction and absorption coefficient in the vicinity of the fundamental bandgap of these III–V materials. The model describes the spectral shape of the absorption edge in terms of bandgap energy, below-bandgap Urbach absorption tail, and above-bandgap power law. The index of refraction in the vicinity of the bandgap is described using Kramers–Kronig integration over the absorption edge. In the analysis, an optical structure model that comprises the sample layer structure and optical constants is constructed to simulate the reflection of polarized light from the sample surface. The optical constant model is implemented within the optical structure model and fit to the measured ellipsometric data with the optical constants of the layer of interest as best-fit parameters. The superlattice measurements exhibit spurious periodic peaks in the optical constants extracted using the point-by-point fit method. Multi-sample analysis of identical midwave superlattices grown at different thicknesses significantly reduces the presence of the spurious peaks and, in general, improves the optical constant fit and the extraction of the absorption edge parameters. In comparing superlattice results, the InGaAs/InAsSb superlattices have a shorter period, demonstrate stronger absorption due to greater electron–hole wavefunction overlap, and exhibit broader absorption tails as a result of greater alloy and interface disorder.
Gray tin (α-Sn) layers with 30 nm thickness were grown on InSb (001) substrates using molecular beam epitaxy. The surface preparation of the substrates was adjusted to achieve either n-type or p-type doping in the α-Sn layer. Fourier-transform infrared ellipsometry was used to find the temperature-dependent dielectric function of the α-Sn layers from 0.03 to 0.8 eV and from 10 to 300 K. Because of the inverted band structure of α-Sn, the spectra show a strong absorption peak at 0.45 eV due to transitions from the inverted Γ7− “electron” valence band to the Γ8+ heavy hole valence band. Applying the Thomas–Reiche–Kuhn f-sum rule, the integrated oscillator strength of this peak was used to calculate the heavy hole concentration as a function of temperature. For a nearly intrinsic α-Sn layer, the heavy hole concentration agrees well with predictions based on degenerate Fermi–Dirac statistics. Deviations from the intrinsic α-Sn carrier concentrations are attributed to substrate surface preparation leading to the diffusion of donor or acceptor ions into the α-Sn layer causing n-type or p-type doping.
The photoluminescence response of a molecular beam epitaxy-grown InGaAsSb/AlGaAsSb multi-quantum well heterostructure is examined as a function of hydrostatic pressure up to 1.35 GPa at a cryogenic temperature of 10 K. Pressure is applied hydrostatically using a diamond anvil cell, within which the pressure is calibrated via ruby fluorescence. A systematic blue shift in the photoluminescence peak energy is observed, with a pressure coefficient of approximately 77 meV/GPa. The integrated photoluminescence intensity decreases systematically with pressure, indicating enhanced non-radiative recombination through a defect level located above the conduction band edge at atmospheric pressure that becomes electronically active at sufficiently high applied pressure. The strain in the quantum well is quantified using the Murnaghan equation of state, and the hydrostatic deformation potential is extracted from the energy-strain relation, yielding a value of a = −4.4 eV. These results provide insight into the pressure-induced modulation of the band structure in quaternary III–V heterostructures and its potential utility for defect studies to improve infrared cameras for advanced aviation.