20 September 2022 in IEEE Transactions on Terahertz Science and Technology
Terahertz frequency-modulated continuous-wave (FMCW) radars operating close to and beyond $f_\text{max}$ often use gain-enhancing lenses to improve the signal-to-noise ratio. A compact single-chip transceiver benefits a lot from the alignment of the lens to the single on-chip antenna in a monostatic system. The typically required coupler for monostatic operation adds an insertion loss. The proposed multiply-by-24 frequency multiplier-based FMCW radar transceiver removes the coupler and integrates both the final 0.48-THz doubler and subharmonic downconverter into a single common collector push-push doubler. The common emitter is the only port at 0.48 THz in this monostatic system, feeding the top-metal on-chip patch antenna using a direct via stack. The 1.42- $\text{mm}^{2}$ monostatic FMCW radar transceiver, manufactured in a 90-nm SiGe BiCMOS technology with an $f_\text{T}$ / $f_\text{max}$ of 300/480 GHz consumes 85 mA when connected to a 3.3-V supply. At 0.48 THz, the output power is $-$ 12 dBm and the single-sideband noise figure is measured as 36.3 dB. FMCW radar measurements with operating bandwidths of up to 55 GHz, corresponding to a theoretical range resolution of 2.73 mm are performed using an on-board frequency source of a credit card-sized demonstrator.
16 June 2023 in IEEE Microwave and Wireless Technology Letters
A 240-GHz 4-transmitter (TX) 4-receiver (RX) 2-D multiple-input–multiple-output (MIMO) frequency-modulated continuous-wave (FMCW) radar transceiver was designed in a 130-nm SiGe bipolar CMOS (BiCMOS) technology with $f_\textit{T}$ / $f_\text{max}$ of 250/370 GHz using patch antennas on a single $4.032\ttimes4.032$ $\text{mm}^\text{2}$ chip. The differential RF inputs, located at the emitters of the direct conversion mixer quad transistors of each RX channel are dc-coupled and current-matched to the differential on-chip patch antenna. At 240 GHz, measurements reveal an RX conversion gain of 24.8 dB, a single-sideband noise figure of 14.9 dB, and an output power of $-$ 2 dBm.
2 November 2023 in IEEE Transactions on Terahertz Science and Technology
A combined common collector harmonic mixer and frequency multiplier is designed to operate at the fourth harmonic in a transceiver at around 0.88 THz in a 90-nm SiGe BiCMOS technology with an f T / f max of 300/480 GHz. The transceiver occupies a chip area of 1.35 $\rm{mm}^{2}$ with a current consumption of 144 mA when connected to a 3.3-V supply. Measurements reveal an effective isotropic radiated power of $-$ 30 dBm at 0.888 THz and a system receiver conversion gain of $-$ 4 dB as well as a single- sideband noise figure of 57 dB at 0.912 THz.
28 December 2023 in e+i Elektrotechnik und Informationstechnik
A 0.46–0.52-THz fully-differential quasi-monostatic frequency-modulated continuous-wave (FMCW) radar transceiver was designed in a 90-nm SiGe bipolar CMOS technology with $$\textit{f}_{ \textit{T}}/{f}_{\text{max}}$$ of 300/480 GHz. The transceiver chip has an area of 2.84 $$\text{mm}^{2}$$ . A multiply-by-24 frequency multiplier chain is used to generate a 0.48-THz signal from a 20-GHz input signal. Two 0.48-THz push–push doublers are driven in quadrature for a differential output signal with a measured effective isotropic radiated power of up to $$-$$ 8.8 dBm at the transmitter at 0.47 THz. A differential subharmonic receiver mixer with a stacked quad topology achieves a measured system conversion gain of 7 dB and a measured single-sideband noise figure of 25.2 dB at 0.471 THz. FMCW radar measurements are performed using an on-board frequency source of a credit card-sized demonstrator at a bandwidth of 60 GHz.