8 September 2023 in IEEE Transactions on Industry Applications
Most current proton exchange membrane fuel cell (PEMFC) fault diagnosis models are not updated after offline training is completed, so they cannot learn new data features. For this problem, a PEMFC fault diagnosis model based on an equivalent circuit and an online sequential extreme learning machine (OS-ELM) framework is proposed. Under different operating conditions, the range of equivalent circuit element values is different, which is conducive to fault diagnosis. Element values constitute a dataset, from which OS-ELM is used to learn data features, and PEMFC fault diagnosis and isolation can be accomplished. OS-ELM has online learning capability. During the operation of PEMFC, equivalent circuit fitting is performed on multiple sets of sample data obtained using electrical impedance spectroscopy (EIS). Optimized fuzzy C-means (FCM) is used to cluster and partition sample data for online updating of OS-ELM models. The experimental results show that the proposed PEMFC fault diagnosis model not only has the speed and accuracy of fault diagnosis but also has the ability to learn fault characteristics online.
11 July 2023 in IEEE Transactions on Industry Applications
All-switches zero voltage switching (ZVS) and lower current stress are the most important challenges for improving the efficiency of dual-active-bridge (DAB) converters operating in the bidirectional full-load range and wide voltage range applications. Triple-phase-shift (TPS) has three control degrees of freedom and it is a more flexible way to extend the ZVS range in all kinds of operating conditions. In order to improve the efficiency of DAB converters, a new optimal current stress in TPS (OCS-TPS) control is proposed to minimize the current stress as well as achieve all-switches ZVS within the bidirectional full-load range and wide voltage range applications. Firstly, seven specific switching modes satisfying the ZVS conditions under step-up and step-down are selected from 12 TPS switching modes. Secondly, the issue of current stress minimization is turned into an extreme optimization problem with equality constraints of desired transmission power and inequality constraints of ZVS conditions in selected switching modes. The Karush-Kuhn-Tucker (KKT) algorithm is employed to solve this optimization issue. Then two switching modes are chosen to form the high-load range ZVS and low-load range partial-switches ZCS/ZVS in the case of step-down and step-up operations respectively. Therefore, the phase-shift ratios of selected switching modes in the low-load range are further optimized by adding an offset value to achieve all-switches ZVS. Finally, the effectiveness of the proposed strategy is verified by the experimental results.
18 September 2023 in IEEE Transactions on Industry Applications
The growing demand for high-efficiency power con-verters with silicon carbide (SiC) devices at high switching frequencies has fueled an interest in non-auxiliary circuit-based soft switching techniques, particularly the variable switching frequency control for zero-voltage switching (VF-ZVS). Besides increasing the Total Harmonic Distortion (THD), applying the full ZVS range to three-phase SiC/Si Hybrid Active Neutral Point Clamped (HANPC) converters leads to a rise in conduction loss. This issue is exacerbated by the use of Si IGBT, as it generates significantly more conduction loss than SiC MOSFET in medium and small power HANPC. Consequently, a power loss optimized VF-ZVS (OVF-ZVS), based on a precise loss model, is proposed to enhance efficiency by considering the effect of the current ripple on device loss. This OVF-ZVS optimizes the switching frequency to minimize the total loss of three-phase switching devices across all load ranges. Meanwhile, the variable switching frequency range and LCL parameters are optimized to strike a balance between superior output current quality, power density, etc. Simulation and exper-imentation using a 10kW HANPC converter prototype illustrate the effectiveness of the proposed comprehensive optimization, further highlighting the reduction in THD and device loss.
19 August 2021 in Journal of Electrical Engineering & Technology