1 February 2013 in Journal of Geotechnical and Geoenvironmental Engineering
Understanding the factors that control the transport of soil particles detached by water is essential in predicting the contingency of internal and surface erosion of embankments during storms and floods. It is particularly useful to be able to evaluate the sensitivity of the available soils to erosion at an early stage of a project and the risk assessment of an existing earthwork. The presented study is based on laboratory tests with a hole erosion test apparatus and tries to characterize the internal erosion of soils. The test consists of eroding a drilled soil specimen by water flow with a constant pressure drop at the boundaries of the specimen while recording the flow rate and studying the hole enlargement. A new version of the apparatus with improved instruments and an interpretation method is proposed, estimating the erosion rate based on the turbidity of the outflow and independent of hydraulic charge. Several remolded kaolinite-sand mixtures are tested as reference soil textures, and the ...
24 May 2012 in European Journal of Environmental and Civil Engineering
AGAntoine Guimond-Barrett
Deep mixing is a method commonly used for various applications ranging from ground improvement and confinement to foundations. With the growth of the use of deep mixing for foundations, it is important to better define the mechanical behaviour and ageing of the material, depending on the cement content and grain size distribution. This study aims to quantify the impact of these parameters as well as the percentage of fines on the mechanical behaviour of the mixed material. A number of unconfined compression tests were carried out. The results showed that it was possible to predict the strength of the mixed material after seven and 28 days of curing, depending on the cement content and the percentage of fines. Also, it was shown that a uniform sand treated with cement presents the same hardening trend for all cement contents. Conversely, a soil with a larger spread of grain size distribution will show different hardening processes, depending on the cement content.
1 March 2013 in Geotechnical Testing Journal
AGAntoine Guimond-Barrett
This paper focuses on the use of free–free resonance testing (FFR testing) applied to the characterization of stabilized silt and sand specimens treated in situ by deep soil mixing. The aim of FFR testing is to measure the natural frequencies of free vibration of the tested specimen. Compression and shear wave velocities, seismic moduli and Poisson’s ratio can be determined from these frequencies. Block samples were taken from soil–cement columns installed at a test site near Paris, France. Specimens of 100 by 50 mm (height to diameter ratio of 2) were cored from these blocks and submitted to FFR testing in the laboratory. The measured resonant frequencies were very repeatable for all specimens tested, validating the use of free–free resonance as a rapid testing method for the characterization of fairly heterogeneous stabilized soil specimens. It was found that both P-wave and S-wave velocities increase nonlinearly with unconfined compressive strength. A linear correlation between strength and dynamic stiffness was observed. Free–free resonance test results can be correlated with index parameters such as density and porosity and used for preliminary assessments of static stiffness as all these parameters varied linearly with measured wave velocities.
1 July 2014 in Geomorphology
9 November 2017 in Geotechnical and Geological Engineering
AGAntoine Guimond-Barrett
1 January 2022 in International Journal of Geomechanics
MDMaria Paola Santisi D’aVila
Maria Paola Santisi D’aVila
The mechanical behavior of binary granular mixtures strongly depends on their initial packing density, stress level, fine content, particle size distribution, mineralogy, and shape. This research aims to investigate the effect on the mechanical behavior of fine-sand mixtures of fine particle fraction through various features: grain size distribution, fine particle size, and plasticity. The concept of equivalent intergranular void ratio is proposed for this analysis. It is correlated to the micromechanical activation of fines within the sand matrix. Monotonic consolidated undrained triaxial tests are carried out for mixtures of coarse particles (sand) and fine particles (silt or clay), in the sand dominant behavior, having various shapes and grain-size distributions. Loose, medium, and dense mixtures are tested using different fine contents and confining pressures. The undrained response is strongly affected by particle interactions, depending on the packing density, particle size, and plasticity. The active fine fraction captures the active contribution of fine particles in the sand skeleton structure. It influences the equivalent intergranular void ratio estimated in these experiments and associated to the steady state of mixtures. The reliability of equivalent state theory and an original formula proposed to estimate the active fine fraction is demonstrated in the case of fine-sand mixtures having plastic fine particles and confirmed for non-plastic fines.