Surface-active additives have a central influence on the wear behavior of rolling bearings. The simultaneous use of different surface-active additives can cause interactions between these additives and influence the formation of a tribological boundary layer required for wear protection. Until now, these interactions between corrosion inhibitors (CI) and extreme pressure / anti wear additives (EP/AW) have been insufficiently investigated. This article therefore presents a method for evaluating the influence of CI on the effect of EP/AW additives in oil-lubricated rolling bearings. In standard FE8 tests according to DIN 51819-3, the mineral oil used with the EP/AW additive zinc dialkyl dithiophosphate (ZDDP) shows insufficient wear protection. By adding the corrosion inhibitor zinc carboxylate, the wear mass can be significantly reduced but not completely eliminated under the same conditions. To evaluate the formation of the tribological boundary layers, further tests are there fore carried out at a higher relative lubricant film height. The influence on the composition of the boundary layer is analyzed using electron probe microanalysis (EPMA). By adding zinc carboxylate, a higher mass coverage can be achieved in the tribological boundary layer than when using ZDDP alone.