30 May 2017 in IEEE Transactions on Geoscience and Remote Sensing
The spreading factor is considered as a key parameter that controls the concentration of the directional distribution of the wave energy. It has been confirmed by many scholars that there is a certain relationship between spreading factor and sea surface wind. In the application of high frequency surface wave radar (HFSWR), spreading factor is extracted from the ratio (R B ) of power spectrum density (PSD) of positive (P B + ) and negative (P B - ) Bragg peaks. To extract accurate spreading factor, the premise is that the PSD of detection unit is as little as possible affected by the adjacent detection units. For narrow-beam radar, digital beamforming (DBF) is easy to meet requirements. But for broad-beam radar, it is very difficult. In this paper, a new scheme is proposed to extract spreading factor from broad-beam HFSWR data with the MUSIC-APES algorithm. Different from spatial filtering by DBF, MUSIC-APES directly estimates the azimuth of positive or negative Bragg waves and their echo amplitudes. For broad-beam radar, this scheme can still achieve high azimuth resolution and accurate amplitude estimation at the same time. It solves the biggest obstacle to extract the spreading factor from broad-beam HFSWR data. To verify the feasibility of this scheme, simulations and experiments are carried out to compare with DBF. The extraction accuracy is improved greatly. The results are very surprising. It shows that spreading factor and wind speed are highly relevant. This may be a new way to extract wind speed in the application of HFSWR.
14 June 2017 in IEEE Geoscience and Remote Sensing Letters
The conventional method of extracting ocean surface currents by high-frequency over-the-horizon radar is based on the fixed first-order Bragg frequency formula and ignores the effects caused by the environment, especially in near-shore areas. In this letter, a current inversion model based on 2-D Fourier series expansion was developed. The first-order Bragg frequency and the Doppler offset induced by radial current are dealt with the bivariate functions of group distance and azimuth angle in the proposed method. By solving an overdetermined matrix equation with the least-square fitting method, the current at each detection grid can be estimated. As the Bragg frequency obtained by this new algorithm is adaptive to the environment, the accuracy of current measurement will be improved. The feasibility and effectiveness of the new method are verified with simulations and experimental results. The currents estimated by the traditional method and the new algorithm are compared with two in situ buoys. Results indicate that the new algorithm possesses comparable accuracy for far-shore areas and better accuracy for near-shore areas when compared with the conventional method.
14 October 2021 in IEEE Transactions on Antennas and Propagation
A theoretical sea echo modeling of the floating-platform (FP) high-frequency hybrid sky-surface wave radar (HSSWR) is presented. The ionosphere is considered to be a no-tilt reflecting plane moving in the vertical direction. Subsequently, the first-order sea clutter cross section with consideration of the platform sway and yaw motion is derived. Simulations are conducted to explore the influences of the ionospheric movement and the platform oscillation motion on the sea clutter power spectrum. The simulation results indicate that the platform sway motion may induce additional peaks that distribute symmetrically concerning the Bragg peaks, while the platform yaw motion and the ionospheric movement may broaden and even split the sea clutter. Experiments are conducted with the newly developed HSSWR system, of which the receiving arrays are simultaneously deployed on a FP and the shoreside. Experimental measurements concerning the frequency shift, Doppler width, and the arrival angle of the E-layer/F-layer ionosphere-reflected direct wave are compared and analyzed. The study demonstrates the feasibility of the proposed modeling and provides valuable guidelines for the sea clutter characteristics analysis and the data quality assessments of the FP HSSWR.
22 July 2019 in IEEE Journal of Oceanic Engineering
This paper proposes a method for extracting the lateral velocity in multitarget cases to improve the ship tracking capability of high-frequency surface wave radar (HFSWR). The method exploits the phase interferometry between two antenna arrays that is done in the time domain after joint frequency-azimuth filtering. First, a frequency filter based on generalized S transform with a variable factor is applied to eliminate the background noise. The variable factor is linked to the target's radial velocity and can control the time and frequency resolutions. We then use two identical subarrays as two receiving channels to implement the azimuth filtering. Based on adaptive minimum-variance distortionless response beamforming, the extraneous signals can be suppressed. Subsequently, the varying slope of the phase difference of the target of interest signal from two channels can be extracted to compute the lateral velocity in a low signal-to-noise ratio scenario. The interference of noise and extraneous target signals is analyzed using simulations, and the effectiveness of the frequency-azimuth filtering method is validated with both simulations and experimental data. In addition, the high spatial resolution ship tracking results over an hour match well with automatic identification system data, demonstrating the feasibility of tracking targets with HF monostatic radar.