The main goal of this work is to study dry sliding wear behavior of NiCrSiB-TiB2plasma sprayed coating against NiCrSiB coating. NiCrSiB-based powders with 10, 20, 40 wt.% TiB2particles content were deposited on steel substrates by plasma spraying. The structure of NiCrSiB-TiB2coatings consists of Ni-based matrix and TiB2and CrB grains. Among the coatings studied, the NiCrSiB-20wt.%TiB2shows excellent wear-resistance. The worn surfaces were observed using scanning electron microscopy and Auger electron spectroscopy to determine the wear mechanisms.
1 August 2019 in Archives of Civil and Mechanical Engineering
In this study the influence of the TiB2, ZrB2, and CrB2 additives into NiAl-intermetallics on their wear behavior under friction conditions at the high temperature in the pair with steel has been investigated. It was shown, that the borides additives have influenced on the wear mechanism, significantly increasing the wear resistance of composite coatings pointed out. Among the coatings studied the NiAl-15 wt. % CrB2 coating showed the best result.
In this study the wettability and interfacial behaviour of the TiC–FeNiCrBSiC and TiB2–FeNiCrBSiC systems were investigated. The wetting experiments were performed by the sessile drop method at 1150°C under a vacuum. The contact angles of TiC and TiB2 wetting by melted Fe-based self-fluxing alloy were 51° and 36°, respectively. Thermodynamic calculations were carried out to understand the metal–ceramic interaction mechanism in the TiC–FeNiCrBSiC and TiB2–FeNiCrBSiC systems. The structure of the interface region in the TiB2–FeNiCrBSiC system was characterized by the optical microscopy and SEM-EDS analysis. The formation of Fe, Ni, Cr and Mo complex borides was revealed within the interface region of the TiB2–FeNiCrBSiC system.
30 April 2019 in Journal of Thermal Spray Technology
The properties of plasma-sprayed composite coatings depend to a large extent on the homogenization of the powders used for their deposition. In order to investigate this relation, mixtures of NiAl and CrB2 (15 and 30 wt.%) powders were prepared via an organic binder (a), hot pressing (b) or sintering (c). The obtained composite agglomerates were sprayed on cylindrical AISI 310S steel pins. Their wear resistance was assessed through a pin-on-disc dry-sliding wear test carried out at 500 °C (a counter-body of NiAl coating was also deposited on AISI 310S). All the composite coatings presented strongly reduced the wear rate when compared with the reference NiAl coatings (9.8 × 10−5 mm3/Nm). Those with 30 wt.% CrB2 addition and obtained via the (a), (b) and (c) routes had 3.8, 2.9 and 1.4 mm3/Nm 10−5, while those with 15 wt.% CrB2 for the same routes had 2.6, 0.9 and 0.7 mm3/Nm 10−5, respectively. The least damage was present in the NiAl (15 wt.% CrB2) coating obtained using route (c), due to the microstructure refinement already achieved at the sintering stage and the good reactive binding of CrB2 with the coating matrix, established during plasma spraying. Increasing the CrB2 addition up to 30 wt.% promotes crack propagation accelerating wear.