17 December 2024 in Nanoscale Advances
In this study, we introduce an in situ synthesis technique for incorporating gold nanoparticles (AuNPs) into a magnetic nanocomposite made of glucosamine and alginate (GluN/Alg) via ionotropic gelation.
19 February 2024 in Materials Advances
A copper-based catalyst CuxSi (3 < x < 5) was prepared using chemical vapor deposition (CVD) of butylsilane (BuSiH3) on copper substrates. By varying the precursor flow, we obtained two catalyst variants, one with and one without a SiCx shell. Both variants exhibited large specific areas, owing to the presence of grown nanostructures such as nanoplatelets, nanowires, nanoribbons, and microwires. Remarkably, the catalytic performance of both variants remained stable even after 720 hours of continuous operation. The porous and thick catalyst layer (over a hundred micrometers) on the substrate significantly increased the residence time of intermediates during the electrochemical CO2 reduction reactions (eCO2RR). We observed a high selectivity towards ethanol (∼79%) in neutral CO2-saturated electrolytes and a high selectivity towards acetic acid (∼72%) in alkaline electrolytes. Importantly, the ratio between generated ethanol and acetate could be shifted by adjusting the pH and applied potential. This work thus establishes copper silicides as robust and promising electrocatalysts for selective CO2 conversion to high-value multi-carbon products.
20 September 2001 in The Journal of Organic Chemistry
10 March 2026 in Results in Engineering
28 February 2019 in Pure and Applied Chemistry
This paper reports an original nonstandard green concept to obtain TiO2 microrods with polyhedral densely stacked 3D nanovoids prepared via the heat treatment of a hydrogen titanate. The intermediate hydrogen titanate was synthesized by a solid-liquid-solid (SLS) route from an ammonia-saturated aqueous solution of TiOSO4 at 0 °C. The effect of the postgrowth thermal annealing procedure to remove ice (water) and the proposed mechanism to explain the underlying transitions from the intermediate precursor to nanostructured TiO2 microrods with stacked 3D nanovoids were investigated. The small-angle X-ray scattering (SAXS) analysis indicates that at temperatures above 500 °C, the release of confined ice (water) takes place, which leads to the creation of self-assembled polyhedral nanovoids open to the surface. Their size ranges from 5 to 78 nm in both length and width, with a depth of ~3.88 nm. The first use of these stacked 1D TiO2 microrods as the working electrode in a photoelectrochemical (PEC) cell for water splitting is demonstrated. The estimated value of ζ-potential depends on both annealing temperature and crystallite size. Anatase sample 1D TiO/800 with ζ-potential (−29.1) mV and average crystallite size ~68 nm was observed to be highly stable in aqueous suspension. The SLS method yields low-cost 1D TiO2 materials possessing high photoreactivity with water. The PEC measurements indicate that three-dimensional hollow structures with a controlled geometry via patterned 1D TiO2 surface are promising materials for hydrogen generation from water splitting.
9 August 2022 in Chempluschem