22 February 2022 in Physical Review Research
We experimentally and numerically investigate the early-time hydrodynamic response of tin microdroplets driven by a ns-laser-induced plasma. Experimentally, we use stroboscopic microscopy to record the laser-induced dynamics of liquid tin droplets and determine the propulsion speed and initial radial expansion rate . The ratio of these two quantities is a key parameter to be optimized for applications in nanolithography, where laser-impacted tin droplets serve as targets for generating extreme ultraviolet light. We explore a large parameter space to investigate the influence of the tin droplet diameter, laser beam diameter, and laser energy on the ratio. We find good agreement when comparing the experimentally obtained and values to those obtained by detailed radiation-hydrodynamic simulations using RALEF-2D. From the validated simulations, we extract the spatial distribution of the plasma-driven pressure impulse at the droplet-plasma interface to quantify its influence on the partitioning of kinetic energy channeled into propulsion or deformation. Our findings demonstrate that the width of the pressure impulse is the sole pertinent parameter for extracting the kinetic energy partitioning, which ultimately determines the late-time target morphology. We find good agreement between our full radiation-hydrodynamic modeling and a generalized analytical fluid-dynamics model [H. Gelderblom et al., J. Fluid Mech. 794, 676 (2016)]. These findings can be used to optimize the kinetic energy partition and tailor the features of tin targets for nanolithography.
1 October 2021 in Plasma Sources Science and Technology
1 March 2023 in Physics of Plasmas
We characterize the properties of extreme ultraviolet (EUV) light source plasmas driven by laser wavelengths in the range and laser intensities of W cm−2 for . Detailed numerical simulations of laser-irradiated spherical tin microdroplet targets reveal a strong laser-wavelength dependence on laser absorptivity and the conversion efficiency of generating in-band EUV radiation. For irradiation, the increase in in-band radiation with increasing laser intensity is offset by only a minor reduction in conversion efficiency. Radiative losses are found to dominate the power balance for all laser wavelengths and intensities, and a clear shift from kinetic to in-band radiative losses with increasing laser wavelength is identified. Yet, with increasing laser intensity, such a shift is absent. We find that the existence of a maximum conversion efficiency, near , originates from the interplay between the optical depths of the laser light and the in-band EUV photons for this specific droplet-target geometry.
1 December 2022 in Physics of Plasmas
We present results from a combined experimental and numerical simulation study of the anisotropy of the expansion of a laser-produced plasma into vacuum. Plasma is generated by nanosecond Nd:YAG laser pulse impact (laser wavelength ) onto tin microdroplets. Simultaneous measurements of ion kinetic energy distributions at seven angles with respect to the direction of the laser beam reveal strong anisotropic emission characteristics, in close agreement with the predictions of two-dimensional radiation-hydrodynamic simulations. Angle-resolved ion spectral measurements are further shown to provide an accurate prediction of the plasma propulsion of the laser-impacted droplet.
22 April 2024 in Applied Physics Letters
Laser-driven tin plasmas are driving new-generation nanolithography as sources of extreme ultraviolet (EUV) radiation centered at 13.5 nm. A major challenge facing industrial EUV source development is predicting energetic ion debris produced during the plasma expansion that may damage the sensitive EUV channeling multilayer optics. Gaining a detailed understanding of the plasma dynamics and ion acceleration mechanisms in these sources could provide critical insights for designing debris mitigation strategies in future high-power EUV sources. We develop a fully kinetic model of tin-EUV sources using one-dimensional particle-in-cell simulations to study ion debris acceleration, which will be valuable for cross-validation of radiation-hydrodynamic simulations. An inverse-bremsstrahlung heating operator is used to model the interaction of a tin target with an Nd:YAG laser, and thermal conduction is included through a Monte Carlo Coulomb collision operator. While the large-scale evolution is in reasonable agreement with analogous hydrodynamic simulations, the significant timescale for collisional equilibration between electrons and ions allows for the development of prominent two-temperature features. A collimated flow of energetic ions is produced with a spectrum that is significantly enhanced at high energies compared to fluid simulations. The dominant acceleration mechanism is found to be a large-scale electric field supported mainly by the electron pressure gradient, which is enhanced in the kinetic simulations due to the increased electron temperature. We discuss the implications of these results for future modeling of tin-EUV sources and the development of debris mitigation schemes.
1 October 2024 in Plasma Sources Science and Technology
The properties of an extreme ultraviolet (EUV) source driven by hundreds-of-nanoseconds-long laser pulses of 2 µm wavelength are investigated through radiation-hydrodynamic simulations. We show that single-pulse irradiation of 30 µm-diameter tin droplets can generate in-band energies mJ directed in the 2π sr solid angle subtended by the collector mirror, yielding energies ∼100 mJ produced from 45 µm-diameter droplets. Time-integrated in-band EUV emission profiles, generated by taking Abel transforms of the local net in-band emissivity, reveal EUV source sizes in the axial (laser) direction × radial direction of ∼600 (1000) × 100 (150) µm2 for 30 (45) µm-diameter droplets. We find that approximately 74% of the total in-band emission is produced during the first half of the total propulsion distance irrespective of droplet size or laser intensity. Furthermore, we propose a one-dimensional analytical propulsion model to qualitatively explain the simulated droplet trajectory and to predict the time taken for the droplet to vaporize. These findings offer motivation for the development of high-power EUV sources based on single-pulse, hundreds-of-nanoseconds-long irradiation of tin droplets.