We report both theoretical and experimental results of a slit beam shaping configuration for fabricating photonic waveguides by use of femtosecond laser pulses. Most importantly we show the method supports focussing objectives with a long depth of field and allows the direct-writing of microstructures with circular cross-sections whilst employing a perpendicular writing scheme. We applied this technique to write low loss (0.39 dB/cm), single mode waveguides in phosphate glass.
We report guiding of laser pulses with peak input intensities greater than in 30 mm and 50 mm long -filled capillary discharge waveguides. Under conditions producing good guiding the coupling and propagation losses of the waveguide were and , respectively. The spectra of the transmitted pulses were not broadened significantly, but were shifted to shorter wavelength. It is concluded that this shift is not associated with significant temporal distortion of the laser pulse.
A hydrogen plasma waveguide for high-intensity laser pulses is described. The guiding channel is formed by a small-scale discharge in a hydrogen-filled capillary. The measured lifetime of the capillary is inferred to be greater than shots. The results of interferometric measurements of the electron density in the capillary are presented. The guiding channel is found to be highly ionized with an axial electron density of and parabolic, the curvature corresponding to a matched spot-size of 37.5 μm.
A one-dimensional dissipative magnetohydrodynamics code is used to investigate the discharge dynamics of a waveguide for high-intensity laser pulses: the gas-filled capillary discharge waveguide. Simulations are performed for the conditions of a recent experimental measurement of the electron density profile in hydrogen-filled capillaries [D. J. Spence et al., Phys. Rev. E 63, 015401 (R) (2001)], and are found to be in good agreement with those results. The evolution of the discharge in this device is found to be substantially different to that found in Z-pinch capillary discharges, owing to the fact that the plasma pressure is always much higher than the magnetic pressure. Three stages of the capillary discharge are identified. During the last of these the distribution of plasma inside the capillary is determined by the balance between ohmic heating, and cooling due to electron heat conduction. A simple analytical model of the discharge during the final stage is presented, and shown to be in good agreement with the magnetohydrodynamic simulations.
We report a continuous-wave self-Raman laser based on diode-pumped Nd:GdVO4 giving first-Stokes output at 1173 nm and intracavity frequency-doubled output at 586.5 nm. A maximum cw output power at 1173 nm of 2 W was obtained for diode pump powers of 22 W and a maximum cw power at 586 nm of 678 mW with 16.3 W pump power. Infrared and yellow powers were limited by thermal lensing in the gain medium and parasitic oscillations of weak Nd3+ transitions. Quasi-cw operation at 50% duty-cycle reduced the thermal load in the laser/Raman crystal, allowing cavity stability to be obtained near maximum available pump power (25.7 W) for which the maximum quasi-cw yellow output power was 1.88 W.