1 April 2024 in IEEE Transactions on Power Electronics
The silicon carbide (SiC) mosfet s provide superior properties over conventional silicon power devices with a higher switching speed and lower conduction losses. However, high-frequency switching can cause overshoots, oscillations, and electromagnetic interference (EMI) issues. Because of a fixed gate driving strength, the traditional gate driver struggles with the tradeoff between overshoot and switching loss (switching speed). To improve the switching performance of the SiC power devices, an active gate driver (AGD) integrated circuit is proposed using a 0.18-μm CMOS HV BCD process is proposed in this article. Instead of requiring a separate programmable logic board, the controller circuits and driving stage are integrated on a chip. The proposed gate voltage sensing technique detects the slope difference of the gate voltage and generates the appropriate gate driving signals without detecting the SiC mosfet I D and V DS information. The area and cost are reduced by removing the high-voltage sensing circuit for I D and V DS detection. The proposed AGD can also attenuate the oscillations of I D and V DS , further reduce the EMI noise induced by high switching speed. In addition, the experimental results show that the proposed AGD can be applied to different SiC power mosfet s.
24 December 2024 in IEEE Transactions on Power Electronics
Silicon carbide (SiC) power mosfets provide superior device characteristics, increasing their demand in high-power systems. However, the advantages of SiC also cause switching challenges, including overshoot, oscillation, and electromagnetic interference (EMI). This article introduces a universal active gate driver (AGD) IC to mitigate these issues and achieve a better tradeoff between overshoot and switching losses (ELOSS). The AGD IC integrates a gate-sensing technique, eliminating the need for external sensing components, and dynamically adjusts driving strength during switching operations, effectively suppressing overshoot, oscillation, and EMI. Moreover, the proposed driver can automatically drive different SiC power devices, enhancing its utility flexibility. Validation using the 0.18-μm BCD process demonstrates the functionality of the proposed AGD, achieving notable reductions of 48.7% and 18.8% in turn-on and turn-off switching losses, respectively, compared to conventional gate drivers under similar current and voltage overshoot. These findings confirm the advancements of the proposed AGD in improving the efficiency and reliability of SiC-based power management systems.
24 May 2023 in IEEE Transactions on Power Electronics
A digital gate driver with active gate driving is effective in solving the tradeoff between switching loss and current/voltage overshoot of power devices. However, the optimum gate driving vector (GV) for a digital gate driver is temperature- and load current-dependent. When an optimum GV at a particular operating condition is reused to another, the switching performance sometimes becomes worse than the conventional gate drive (Sai et al. 2019). Therefore, robust gate driving vectors (RGVs) against temperature and load current variation are required (Sai et al. 2019). Nevertheless, the test cost of searching for an RGV is very high. In order to reduce the test cost, search methods of RGV with fewer required measurements are proposed in this article. Single-step GV and stop-and-go GV are selected as the type of RGV for turn- on and turn- off , respectively. Compared with the conventional search method of RGV in Sai et al. 2019 and Wang et al. 2020, the proposed search method can reduce the measurement time by 99% and 92%, respectively. Furthermore, when the RGV and the optimum GV at a single condition are reused to other operating conditions, the maximum overall f OBJ of RGV is lower than that of the single condition optimum GV, which shows that the searched RGV has better robustness.