1 May 2021 in Materials Research Express
AlCrTaTiZr, AlCrTaTiZr nitride, and AlCrTaTiZr oxide coatings as tritium permeation barriers (TPBs) were prepared by magnetron co-sputtering technology on a CLF-1 (RAFM) substrate, to evaluate their hydrogen/deuterium permeation resistance. X-ray diffraction (XRD) analysis showed that the as-deposited coatings were amorphous. Scanning electron microscopy (SEM) results revealed that the deposition rates of the AlCrTaTiZr coating, AlCrTaTiZr nitride coating and AlCrTaTiZr oxide coating were approximately 2 μm h−1, 0.75 μm h−1 and 0.15 μm h−1, respectively. The properties of these high-entropy alloy (HEA) coatings were studied with electrochemical hydrogen (ECH) permeation test equipment and a high-temperature gas-driven deuterium permeation (GDP) device. The AlCrTaTiZr HEA coating had the best hydrogen permeation resistance during the electrochemical hydrogen permeation test. However, the AlCrTaTiZr nitride coating had the best deuterium permeation resistance during the gas-deuterium permeation test. Annealing experiments of these coatings showed that changes in their microstructures during the gas-driven deuterium permeation test were the main reasons for the different permeabilities of these coatings during the heating and cooling processes. The oxidization of the HEA coating during the deuterium permeation experiment may have been the main reason that the HEA coating showed better deuterium permeation resistance than the HEA oxide coating.
1 December 2020 in Materials Research Express
Beryllium is considered as a candidate of ITER first-wall (FW) armor and neutron multiplier in fusion reactors. To assess the irradiation resistance of CN-G01 beryllium, which has been accepted as an alternative ITER-grade beryllium in China, 180 keV helium ions with fluences of 1.0 × 1017 ions cm−2, 5.0 × 1017 ions cm−2 and 1.0 × 1018 ions cm−2 were implanted at room temperature. The theoretical simulation of energy loss, damage distribution and helium concentration were proceeded by SRIM. In this paper, we report the experimental exploration of ion fluence effect on surface morphology and microstructure of irradiated samples. Field Emission Scanning Electron Microscope (FESEM) analysis depicted the formation and growth of helium bubbles at different irradiation ion fluences. No obvious exfoliation or cavities was observed on the surface at all ion fluences, suggesting a reliable radiation resistance of CN-G01 beryllium. Atomic force microscopy (AFM) morphology showed that the maximum height of bubbles was 47.8 nm. Surface roughness values increased slightly due to the formation of defects and bubbles on the irradiated beryllium surface. Nevertheless, the structural analysis demonstrated by grazing incidence x-ray diffraction (GIXRD), indicated an obvious preferred orientation on (101) peak at various ion fluences. Annihilation of defects caused by a small rise of the localized temperature could explain the increasing intensity of diffraction peak (101).