The effect of weldments in service performance of high temperature components has been subject to intensive research due to the fact that in the majority of cases where high temperature failure occurs, defects predominate in the vicinity of weldments. Cracking occurs in service due to reduced creep ductility of HAZ and weld metal due to ageing in service, combined with the action of multi-axial stress fields that reduce the creep ductility further. The defects detected or assumed to exist through minimum allowable limits of detectable flaws using non-destructive testing methods is required for structural integrity and residual life assessment of high temperature components. The assessment relies on information obtained from the material’s high temperature tensile, uniaxial creep, crack initiation and growth properties. The concepts used for time dependent fracture analysis of homogeneous bodies are commonly applied for creep crack growth in weldments that show multi-crack initiation and crack branching. This calls for study of deformation behavior and applicability of fracture mechanics parameters for high temperature assessment of weldments. The present paper reports on the material behavior and methodology followed for testing and assessment of the high temperature steel weldments.
30 August 2021 in Wood Material Science & Engineering
This study aims to study the improvement in the properties of heat-treated wood material by impregnation. For this purpose, black pine (Pinus nigra Arnold) wood specimens were modified in two stages: impregnation with 1%, 3% and 5% of diammonium phosphate (DAP) and sodium carbonate (SC) compounds followed by heat treatment at four different temperatures. Test specimens were pre-treated with solutions of different pH values of either DAP or SC solutions according to the immersion method and they were exposed to heat treatments at 150°C, 170°C, 190°C and 210°C for 3 h. Some physical and mechanical properties were determined in combined treated specimens with air-dried density, compression strength parallel to grain (CS) and bending strength (MOR). The test results indicated that, as regards the effect of the heat treatment, the mechanical strength decreased due to the increase in temperature, while the losses in the CS were fewer than those of the MOR. In addition, generally combined treatments increased the mechanical properties of the specimens, especially at lower and moderate heat treatment temperatures. Moreover, the SC compound showed more favorable results against the reducing effect of the heat treatment on mechanical strengths.
11 August 2010 in International Journal of Pressure Vessels and Piping