1 February 2018 in Renewable and Sustainable Energy Reviews
18 February 2022 in IETE Journal of Research
In many industrial processes, e.g. temperature and level control, chemical reactors can be classified as a variant of integrating plus time-delay system. Controlling these processes is a difficult task due to open-loop instability, which consists of time-delay and unbounded output for bounded input. 1DOF PID control always leads to a large overshoot in set-point tracking for IPTD processes. In a 2DOF PID structure, tuning the set-point weights and the controller parameters is important to achieve good tracking and disturbance rejection properties. But tuning the set-point weights and the parameters of the cascade-feedback controller together is a difficult task. Usually, predetermined values for set-points are chosen, and a controller design is followed. In the present work, an alternative simple approach to obtain controller parameters along with set-point weights is presented which are tuned to yield good tracking and load–disturbance rejection. Explicit controller parameters for different classes of integrating processes are obtained using gain-margin, phase-margin, and inverse plant model which can also be used for controller auto-tuning. To validate the effectiveness of the proposed controller, simulation comparisons with some recently developed methods are included. Moreover, the experimental validation of the proposed controller on a temperature control plant is also presented.
18 December 2017 in International Transactions on Electrical Energy Systems
12 October 2022 in IEEE Transactions on Dielectrics and Electrical Insulation
The homo-charges accumulated inside the polymeric insulation of high voltage dc (HVdc) cables increase the electrical field beyond the uniform value, whereas the hetero-charges reduce it. Such uneven electrical field distribution is detrimental to HVdc cables’ longevity and thus, needs to be identified accurately. To this end, this article proposes a deep learning (DL) framework for the automated detection of space charges in HVdc cable insulation. The space charges inside the cross-linked polyethylene (XLPE) insulation samples were measured under varying electric fields (10–50 kV/mm) as well as at different temperatures (30 °C–70 °C) conditions. The obtained space charge profiles corresponding to no charge, hetero-charge, and homo-charge categories were fed to two benchmark convolutional neural network (CNN) models, i.e., AlexNet and VGGNet16, for automated feature extraction and classification purpose. The convolutional blocks of the two CNN models were sequentially fine-tuned using transfer learning (TL) to observe the variation in classification accuracies. The proposed approach delivers appreciably high classification accuracies irrespective of varying electric field and temperature conditions with reduced computational time toward distinguishing different categories of space charge accumulations compared to other CNN models. Hence, it can be potentially used for real-time HVdc insulation diagnostic purposes.
7 June 2021 in International Journal of Emerging Electric Power Systems
Multilevel inverters (MLIs) have formed a new wave of interest in research and industry. Switched capacitor-based multilevel inverters are used to avoid the need for multiple separated DC sources compared to cascaded MLIs. However, the inclusion of several capacitors creates problems such as high inrush current, voltage imbalance. To avoid these drawbacks, this paper proposes an isolation-based scheme by using a flyback converter in the switched capacitor multilevel inverter. Further, the overall topology provides step-up AC voltage across the load from a single DC source with fewer power switches. To generate a step-up five-level voltage across the load, switched capacitor-based multilevel inverter needs six power switches and only one capacitor. To get the appropriate switching operation to generate the NL- levels, phase disposition pulse width modulation (PD-PWM) has been developed. The extended nine-level S
2
-MLI is also discussed in this paper under different conditions as change in input source voltage and dynamic load change. Moreover, to prove the superior performance of switched-capacitor single DC source multilevel inverter (S 2 -MLI), comparative analysis with existing single DC source MLI has been performed. The effectiveness and feasibility of the proposed topology are tested with varieties of loads by simulation using Matlab/Simulink. To validate the simulation results, hardware implementation has been done of five-level S 2 -MLI considering resistive and motor load by using DSpace 1103 controller.
14 July 2023 in IEEE Transactions on Instrumentation and Measurement
Formation of micro-cavities takes place inside high-voltage cross-linked polyethylene (XLPE) cable insulation due to severe electrical and thermal aging, which further act as sources of void discharges and lead to the development of dendritic carbonyl channels, commonly referred to as electrical trees. Accompanied by intermittent partial discharge (PD) activities, the electrical tree growth bridges the entire insulation over time and results in insulation breakdown, which exposes the cable to fatal safety incidents. Therefore, accurately identifying various stages of electrical tree growths is crucial to prevent such safety instances as well as ensure reliable and extended operation of the XLPE cable. To this end, the present study proposes an automated electrical tree growth monitoring scheme employing a customized 19-layer residual neural network (ResNet) model. For this purpose, microscopic images of different tree growth stages inside XLPE insulation samples were acquired at different temperatures (30, 50, and 70 °C) and augmented using a deep convolutional generative adversarial network (DCGAN). Further, using fractal dimension ( df ) of the tree structures, different electrical tree propagation levels were characterized. Finally, different tree growth stages were identified using the proposed 19-layer ResNet model. This approach yielded satisfactorily high recognition accuracies irrespective of varying temperatures, engaging a significantly reduced computational time compared to classical convolutional neural network (CNN) models. This infers its potential application for automated health monitoring of XLPE cable.