Zhanaly Bekturganov

Zhanaly Bekturganov

Auto-generated profile, based on publicly available information

Zhanaly Bekturganov

Karaganda national research university named after Ye.A. Buketov

Research Focus & Metrics

Academic Career Length

1Year (2026-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
30 September 2026 in Eurasian Physical Technical Journal
Verified
Journal Article
Open access
PDF file
SSSaule Sakipova
Saule Sakipova
ZSZhanaidar K Smagulov
Zhanaidar K Smagulov
ZBZhanaly S Bekturganov
Zhanaly S Bekturganov
ZIZharaskan T Ismailov
Zharaskan T Ismailov
GKGulnaz Kartbayeva
Gulnaz Kartbayeva
DODidar A Ospanova
Didar A Ospanova
The article presents an evaluation of the performance of a ground-source heat pump system designed to maintain a specific temperature regime within a biogas bioreactor. The novelty and distinctive feature of the installation lie in its use of renewable thermal energy sources. For the first time, a system with an external ground-source heat pump circuit consisting of four boreholes with copper U-shaped tubes through which the coolant circulates has been developed. The system's design, operating principle, and technical specifications are described. An assessment of the thermal energy output, accounting for the efficiency characteristic of the external circuit of a ground-source heat pump is shown.

30 October 2026 in Eastern-European Journal of Enterprise Technologies
Verified
Journal Article
Open access
PDF file
BNBekbolat Nussupbekov
Bekbolat Nussupbekov
AKAitkul Kongyrbayeva
Aitkul Kongyrbayeva
YOYerlan Oshanov
Yerlan Oshanov
ZSZhanaidar Smagulov
Zhanaidar Smagulov
ZBZhanaly Bekturganov
Zhanaly Bekturganov
ZIZharaskan Ismailov
Zharaskan Ismailov
The object of this study is the process of heating water inside a rotating perforated barrel. The effect of the number of holes and their total area on the heating rate and temperature unevenness has still not been studied, so the configuration of the holes is selected by testing prototypes. Mathematical modeling was carried out in the ANSYS LS-DYNA software package to determine the heating of water for 15 configurations with 4 to 12 holes and a total cross-sectional area of 113 to 452 mm2. The angle of inclination of the holes was taken as a further variable, and its optimum of about 30° was confirmed by a genetic algorithm with the LS-OPT surrogate meta-model. The heating rate first increases and then decreases with the number of holes. At a total area of 226 mm2, it reaches 0.92 K/s for 8 holes, while for 4 and 12 holes it is 0.72 and 0.68 K/s, respectively. For the configuration with 8 holes, the temperature unevenness is also the smallest (1.2 K). The maximum is explained by the balance of two mechanisms. A small area gives a high velocity of the jets that cause cavitation, while a large area gives a high flow rate of the liquid through the cavitation zone. A feature of the approach is that the heating rate was taken as the criterion, and the temperature unevenness was evaluated separately. The genetic algorithm confirmed that this configuration is the best in the studied range, so the configuration can be found by calculation before testing a prototype, and the number of prototypes can be reduced. Only the qualitative patterns of the calculation correspond to the experimental data for a rotor with throttle holes. The energy efficiency of the heater was not evaluated. Therefore, this configuration is proposed as the first option for experimental testing of inertial heaters for a liquid with density and viscosity close to those of water