21 September 2023 in Solar Energy
28 February 2023 in Energy
30 October 2020 in Energy Sources, Part A: Recovery, Utilization, and Environmental Effects
SSSenthilkumar Subramaniam
The effect of partial shading results in increased mismatch losses and decreased power output of the solar Photovoltaic (PV) array, requiring reconfiguration of the shading pattern of the panels. Hence, various interconnection schemes and shade dispersing techniques are used to increase the power harnessed from the PV array. This paper proposes a simple offline shade dispersion in the entire PV array using a fixed reconfigured interconnection scheme. MATLAB/Simulations are carried out on a 6 × 6 PV array with fairly larger rating with different shading patterns and an experimental set up has also been developed with a 3 × 3 PV array with a much smaller rating in the laboratory for validating the reduction in mismatch loss and increased fill factor for different shading patterns. This technique can be used for both square and rectangular PV arrays. The proposed interconnection scheme has been compared with the Total Cross Tied (TCT) connection and shown that there is an enhancement of power generation, for about 16.66% in short-narrow shading pattern and a reduction in power loss of 66.66% in a short-wide pattern.
16 May 2022 in Energy Sources, Part A: Recovery, Utilization, and Environmental Effects
Solar photovoltaic (PV) is the widely preferred power generation source to meet the growing energy demands. Solar PV system must be made highly reliable and effectively utilized during the availability of the source. System reliability is the predominant factor to be considered because of the possibilities of various faults and various operating conditions to which PV system is subjected. The present work addresses three major faults that commonly occur in solar PV system, namely, failure of bypass diode, failure of PV module, and power generation mismatch due to panel replacement. This proposed work deals with the detection and clearance of these three faults. The failure of PV module results in a higher power reduction of 82% in the PV array. The switching matrix circuit is proposed to enhance the power obtained from PV system under the module failure fault. The faults are manually created in a typical 1.5 kW grid-connected PV system and rectified to enhance the power production in the PV array. An average power enhancement of 14% is obtained after the clearance of the power mismatch due to panel replacement. With the help of double bypass diode technique, output power is enhanced to 55.2% higher compared to before fault clearance at the same irradiance level. The experimental results obtained in 1.5 kW grid-connected solar PV system are studied and validated.
13 January 2024 in Electrical Engineering
10 January 2024 in Energy Technology