We have developed a silicon photonics receiver integrated with a SiGe-BiCMOS linear transimpedance amplifier (TIA) using the flip-chip bonding technology to assist in resolving the I/O bottleneck problem in inter-chip data communication. The proposed device demonstrated optical 112 Gb/s four-level pulse amplitude modulation (PAM-4) operations and clear eye openings without any equalization for the pseudorandom binary sequence $2^{\mathbf {15}}$ – 1 signal. The 3 dB bandwidth and transimpedance gain were designed to be 37.1 GHz and 60.1 dB $\boldsymbol {\Omega } $ , respectively, at a supply voltage of 3.3 V. The consumption current of the linear TIA was 95.1 mA, and it resulted in a power consumption of 314 mW (2.8 pJ/bit). A linear TIA circuit is a key technology for PAM-4 operation; therefore, we discussed the linearity of our receiver response through eye diagrams and simulation. The measured eye diagrams agreed with the simulation results, and the proposed device maintained a linear response for up to 450 $\boldsymbol {\mu }\text{A}_{\mathbf {p-p}}$ input current. In addition, its operation rate of 112 Gb/s is the highest operation rate reported for a silicon photonics PAM-4 receiver based on flip-chip 3D integration with a germanium photodetector and a SiGe-BiCMOS linear TIA.
1 February 2008 in IEICE Transactions on Electronics
LSI on-chip optical interconnections are discussed from the viewpoint of a comparison between optical and electrical interconnections. Based on a practical prediction of our optical device development, optical interconnects will have an advantage over electrical interconnects within a chip that has an interconnect length less than about 10mm at the hp32-22nm technology node. Fundamental optical devices and components used in interconnections have also been introduced that are small enough to be placed on top of a Si LSI and that can be fabricated using methods compatible with CMOS processes. A SiON waveguide showed a low propagation loss around 0.3dB/cm at a wavelength of 850nm, and excellent branching characteristics were achieved for MMI (multimode interference) branch structures. A Si nano-photodiode showed highly enhanced speed and efficiency with a surface plasmon antenna. By combining our Si nano-photonic devices with the advanced TIA-less optical clock distribution circuits, clock distribution above 10GHz can be achieved with a small footprint on an LSI chip.
1 August 2008 in Japanese Journal of Applied Physics
Optical transmitter and receiver ICs, each with a footprint of 25 mm 2 , were fabricated using a silicon photonics platform based on 40-nm-node CMOS technology. High-speed transmissions of data at 300 Gbps were demonstrated. The wire-type waveguide (WG) in the transmitter IC had a width of 350 nm and a height of 200 nm, and in the completed optical IC, it showed low propagation loss (1.62 dB/cm) for the O-band transverse electric mode and low propagation loss variation (0.15 dB/cm) at 3σ. The coupling loss of the grating couplers was reduced to 2.7 dB by using an apodization structure with a narrow trench width of 70 nm. The wafer-scale reproducibility of the WG width was excellent, as confirmed by a spectral variation analysis using a large number of the microring resonators. The surface-illumination photodetectors (PDs) of the optical receiver were made using a germanium epitaxial film and had a leakage current of less than 10 nA at 3 V and a responsivity of 0.75 A/W. The modulation efficiency of the PN-junction-type Mach-Zehnder modulators of the optical transmitter was 1.3 V . cm at 0 V. The uniformity of the PDs and modulators on a 300-mm wafer was very high. By using the fabricated optical transmitter and receiver ICs, data transmissions at up to 12 × 25 Gbps in the O band (1.3 μm) were demonstrated. Furthermore, low-loss filtering operation in 1:4 channel delayed interferometer-based demultiplexing was shown to enable even faster data transmissions. These results indicate that our silicon photonics platform is very useful for fabricating wideband optical ICs.
Optical interconnects integrated with lasers, silicon optical modulators and germanium photodetectors on a single silicon substrate were demonstrated for the first time. A 5 Gbps line bit rate and 3.5 Tbps/cm2 transmission density were achieved.
11 March 2025 in IEEE Transactions on Components, Packaging and Manufacturing Technology
In this paper we report on the design and performance of a silicon photonics micro-transceiver, which is designed to operate in harsh environments including high temperature environments above 105°C and space environments. In addition, we demonstrated that the micro-transceiver modules have been applied to immersion cooling, which must be considered another harsh environmental condition due to its novelty for optical active components. The four-channel “IOCore®” micro-transceiver incorporates a 1310 nm quantum dot laser system and operates at a symbol rate of 32 GBaud and higher. The 5 x 5 mm micro-transceiver chip benefits from a multimode coupling interface for low-cost assembly and robust connectivity at high temperatures.