Koichi Takemura

Koichi Takemura

Auto-generated profile, based on publicly available information

Koichi Takemura

Photonics Electronics Technology Research Association (PETRA), Tsukuba, Japan

Research Focus & Metrics

Academic Career Length

25Years (2002-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
18 July 2022 in IEEE Photonics Technology Letters
Verified
Journal Article
Open access
ANAkihiro Noriki
Akihiro Noriki
ITIsao Tamai
Isao Tamai
YIYasuhiro Ibusuki
Yasuhiro Ibusuki
AUAkio Ukita
Akio Ukita
SSSatoshi Suda
Satoshi Suda
TATakeru Amano
Takeru Amano
We previously proposed a new package substrate called active optical package (AOP) substrate to realize co-packaged optics. An optical redistribution technology on silicon photonics dies was developed to fabricate the AOP substrate. It is composed of a polymer waveguide, with a mirror-based optical coupling between the polymer and silicon waveguides. The fabricated optical redistribution loss was characterized in this study. An average loss of approximately 4 dB and wavelength dependent loss of ±1 dB were observed for the wavelength range of 1460–1600 nm. It was shown that the low wavelength-dependent optical redistribution was available owing to the broadband characteristics of mirror-based optical coupling and polymer waveguide.

20 January 2022 in IEEE Photonics Technology Letters
Verified
Journal Article
Closed access
DODaisuke Okamoto
Daisuke Okamoto
YSYasuyuki Suzuki
Yasuyuki Suzuki
KTKoichi Takemura
Koichi Takemura
JFJunichi Fujikata
Junichi Fujikata
TNTakahiro Nakamura
Takahiro Nakamura
We have developed a silicon photonics receiver integrated with a SiGe-BiCMOS linear transimpedance amplifier (TIA) using the flip-chip bonding technology to assist in resolving the I/O bottleneck problem in inter-chip data communication. The proposed device demonstrated optical 112 Gb/s four-level pulse amplitude modulation (PAM-4) operations and clear eye openings without any equalization for the pseudorandom binary sequence $2^{\mathbf {15}}$ – 1 signal. The 3 dB bandwidth and transimpedance gain were designed to be 37.1 GHz and 60.1 dB $\boldsymbol {\Omega } $ , respectively, at a supply voltage of 3.3 V. The consumption current of the linear TIA was 95.1 mA, and it resulted in a power consumption of 314 mW (2.8 pJ/bit). A linear TIA circuit is a key technology for PAM-4 operation; therefore, we discussed the linearity of our receiver response through eye diagrams and simulation. The measured eye diagrams agreed with the simulation results, and the proposed device maintained a linear response for up to 450 $\boldsymbol {\mu }\text{A}_{\mathbf {p-p}}$ input current. In addition, its operation rate of 112 Gb/s is the highest operation rate reported for a silicon photonics PAM-4 receiver based on flip-chip 3D integration with a germanium photodetector and a SiGe-BiCMOS linear TIA.

8 June 2023 in Journal of Lightwave Technology
Verified
Journal Article
Open access
ANAkihiro Noriki
Akihiro Noriki
AUAkio Ukita
Akio Ukita
KTKoichi Takemura
Koichi Takemura
SSSatoshi Suda
Satoshi Suda
TKTakayuki Kurosu
Takayuki Kurosu
TATakeru Amano
Takeru Amano
To realize a new package substrate for co-packaged optics, a silicon-photonics hybrid glass-epoxy substrate was demonstrated. In the substrate, silicon photonics dies working as optical/electrical conversion engines are embedded. Additionally, it includes optical redistribution composed of polymer waveguides and mirror-based optical coupling structures between the polymer and silicon waveguides. A demonstration sample was designed for a total bandwidth of 10 Tbps using silicon photonics dies with arrayed waveguide gratings, wavelength splitters, and polarization splitters/rotators for 16-ch wavelength division multiplexing (WDM). It was fabricated using unique key technologies, such as silicon photonics embedding, micromirror fabrication, and single-mode polymer waveguide fabrication. Its wavelength multiplexing operation and signal transmission characteristics were evaluated. As a result, the hybrid substrate was discovered to be capable of 112 Gbps pulse amplitude modulation 4 (PAM-4) transmission with a 16-ch WDM function because the transmitter dispersion and eye closure quaternary (TDECQ) values of less than 3.4 dB were obtained and 16-ch WDM spectrum were clearly visible. To the best of our knowledge, the working of such a hybrid substrate was demonstrated for the first time. This demonstration implies that the hybrid substrate is feasible, and the above-mentioned novel technologies are crucial to its development.

6 August 2018 in Journal of Lightwave Technology
Verified
Journal Article
Closed access
TMTohru Mogami
Tohru Mogami
AUAkio Ukita
Akio Ukita
KTKoichi Takemura
Koichi Takemura
MKMitsuru Kurihara
Mitsuru Kurihara
KYKenichiro Yashiki
Kenichiro Yashiki
TSTakanori Shimizu
Takanori Shimizu
Optical transmitter and receiver ICs, each with a footprint of 25 mm 2 , were fabricated using a silicon photonics platform based on 40-nm-node CMOS technology. High-speed transmissions of data at 300 Gbps were demonstrated. The wire-type waveguide (WG) in the transmitter IC had a width of 350 nm and a height of 200 nm, and in the completed optical IC, it showed low propagation loss (1.62 dB/cm) for the O-band transverse electric mode and low propagation loss variation (0.15 dB/cm) at 3σ. The coupling loss of the grating couplers was reduced to 2.7 dB by using an apodization structure with a narrow trench width of 70 nm. The wafer-scale reproducibility of the WG width was excellent, as confirmed by a spectral variation analysis using a large number of the microring resonators. The surface-illumination photodetectors (PDs) of the optical receiver were made using a germanium epitaxial film and had a leakage current of less than 10 nA at 3 V and a responsivity of 0.75 A/W. The modulation efficiency of the PN-junction-type Mach-Zehnder modulators of the optical transmitter was 1.3 V . cm at 0 V. The uniformity of the PDs and modulators on a 300-mm wafer was very high. By using the fabricated optical transmitter and receiver ICs, data transmissions at up to 12 × 25 Gbps in the O band (1.3 μm) were demonstrated. Furthermore, low-loss filtering operation in 1:4 channel delayed interferometer-based demultiplexing was shown to enable even faster data transmissions. These results indicate that our silicon photonics platform is very useful for fabricating wideband optical ICs.

5 June 2023 in Journal of Lightwave Technology
Verified
Journal Article
Open access
FNFumi Nakamura
Fumi Nakamura
SSSatoshi Suda
Satoshi Suda
TKTakayuki Kurosu
Takayuki Kurosu
YIYasuhiro Ibusuki
Yasuhiro Ibusuki
ANAkihiro Noriki
Akihiro Noriki
TATakeru Amano
Takeru Amano
Because traffic toward and inside datacenters is increasing, the power consumption of electrical wiring in ethernet switches for datacenter should be addressed. Co-packaged optics (CPO) is a promising solution, where optical components are integrated into the same package substrate as electrical elements. We have proposed one of the CPO modules, where micro-mirror- based optical redistribution is adopted for low-loss and broadband optical coupling. CPO is required to operate at high temperatures; however, this redistribution uses materials with different coefficients of thermal expansion; thus, there is concern about its operation. In this study, the thermo-optical characteristics in the C-band were analyzed by the finite element method for thermal deformation and physical optical propagation analysis. The coupling efficiency of more than 85% was obtained at 1550 nm in the specified temperature range of 15–85 °C, and the difference in the average coupling loss between 20 °C and 85 °C was 0.49 dB in the calculation. The temperature-dependent transmittance was experimentally demonstrated using fabricated optical redistribution, and the average loss difference in C-band was 0.80 dB at 25 °C, 55 °C, and 85 °C.

22 November 2002
Verified
Conference Paper
Closed access
TNT.B. Nishimura
T.B. Nishimura
KYK. Yamaguchi
K. Yamaguchi
NIN. Iwata
N. Iwata
MTM. Tomita
M. Tomita
KTK. Takemura
K. Takemura
YMY. Miyasaka
Y. Miyasaka
This paper describes single 2.2 V operation of a two-stage MMIC power amplifier for 2.4 GHz wireless local area network applications. The MMIC with 0.76/spl times/ 0.96 mm/sup 2/ area is composed of n-AlGaAs/InGaAs/n-AlGaAs FETs with a shallow threshold voltage of -0.24 V and SrTiO/sub 3/ capacitors. The capacitors with a high relative dielectric constant of 180 were employed. Under single 2.2 V operation, the developed MMIC delivered an output power of 22.6 dBm (182 mW) and a power-added efficiency of 33.2% with an associated gain of 22.7 dB at 2.48 GHz.